Control methodology of synchronous lifting for the dual forging manipulator at clamping condition
Open Access
- 10 March 2022
- journal article
- research article
- Published by Springer Nature in Scientific Reports
- Vol. 12 (1) , 1-12
Abstract
Asynchronous coupling force of dual forging manipulator frequently results in poor forging and even equipment failure. In this paper, a synchronous control strategy in dual forging manipulator systems (DFMS) is proposed to stabilize its operation. Kinematic model of the hanging system and finite element model of the forgings are established to investigate the relationships of tension, forging deformation and deformation rate. The rigid-flexible coupling model of DFMS is further established and simulated concerning hydraulics, mechanics and controls. A correction based on the independent feedback state difference is concerned, simulated results show good agreements with experimental data, validating the dead zone compensation algorithm of the proportional valve. Moreover, by the control strategy, the vertical synchronous error of the pincers end is rather small as ± 0.125 mm. The methodology presented in this paper represents a fundamental step towards the cooperation of DFMS and the press to realize collaborative operations.Keywords
Funding Information
- National Natural Science Foundation of China (52175064, 52175064, 52175064)
This publication has 26 references indexed in Scilit:
- Simulation and Optimization of Synchronization Control System for CFETR Water Hydraulic Manipulator Based on AMEsimJournal of Fusion Energy, 2015
- An improved Synchronous Control Strategy based on Fuzzy controller for PMSMElektronika ir Elektrotechnika, 2014
- Collaborative Synchronization Digital Control for Double Hydraulic CylindersAdvances in Mechanical Engineering, 2014
- Application Research on Learning Strategy Control of Daul-Cylinder Synchronous MovementApplied Mechanics and Materials, 2013
- Impedance analysis of forging process and strategy study on compliance for forging manipulatorChinese Journal of Mechanical Engineering, 2013
- Forgeability and die-forging forming of direct chill casting Mg–Nd–Zn–Zr magnesium alloyMaterials Science and Engineering: A, 2010
- Inverse Dynamics Modeling and Nonlinear Controller Design of the Similar Model of a Forging ManipulatorJournal of Mechanical Engineering, 2010
- Calculation of Contact Forces of Large-Scale Heavy Forging Manipulator GrippersKey Engineering Materials, 2009
- Simulated comparison on kinematics properties of two typical mechanisms of forging manipulator2007
- Design of new adaptive fuzzy logic controller for nonlinear plants with unknown or time-varying dead zonesIEEE Transactions on Fuzzy Systems, 1998