Impact behavior of particles filled‐glass/polyester composite plates
Authors:
- 8 June 2011
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 32 (7) , 1125-1133
Abstract
The aim of the study is to lay bare the impact behavior of filled composite plates experimentally. The woven glass/polyester‐matrix composite plates filled with 0% (unfilled), 10%, and 20% SiCp ceramic particles were manufactured by hand lay‐up method. The low velocity drop impact testing is conducted to the composite samples subjected to increasing impact energies that were ranged from approximately 2.5 to 22.5 J. With this use of increasing impact energies, it was possible to examine the impact response and damage mechanism until perforation of the composite plates. An energy profiling method was used in order to identify the perforation thresholds of composites. It is concluded that addition of particles to resin, until a certain ratio, increases the perforation thresholds of the woven glass/polyester. The perforation threshold of 10% filled composite is about 37% higher than that of the 20% filled composite and 6% higher than ones of the unfilled composite. POLYM. COMPOS., 2011. © 2011 Society of Plastics EngineersKeywords
This publication has 25 references indexed in Scilit:
- An investigation on the dynamic response of polymeric, metallic, and biomaterial foamsComposite Structures, 2010
- Dynamic Mechanical and Impact Property Correlation of Nanoclay and Graphite Platelet Reinforced Vinyl Ester NanocompositesJournal of Reinforced Plastics and Composites, 2009
- Repeated impact behavior of glass/epoxy laminatesPolymer Composites, 2008
- The properties of epoxy resin coated silica fillers compositesMaterials Letters, 2007
- Mechanical properties of iron powder filled high density polyethylene compositesMaterials & Design (1980-2015), 2007
- Investigation of the Friction and Wear Behavior of Glass-Epoxy Composite With and Without Graphite FillerJournal of Reinforced Plastics and Composites, 2007
- Fabrication and mechanical characterization of carbon/SiC-epoxy nanocompositesComposite Structures, 2005
- Yield and internal stresses in aluminum filled epoxy resin. A compression test and positron annihilation analysisPolymer, 2003
- Impact perforation resistance of laminated and assembled composite platesInternational Journal of Impact Engineering, 2000
- Dynamic viscoelastic properties and thermal properties of Ni powder-epoxy resin compositesJournal of Applied Polymer Science, 1998