A Novel MEMS Speaker With Peripheral Electrostatic Actuation
- 25 June 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 29 (4) , 592-599
Abstract
We design and fabricate electrostatically actuated micro-speakers with circular diaphragms and peripheral electrode configuration. The novel electrode configuration mitigates the squeeze film damping and increases pull-in voltage when compared with the conventional parallel plate electrostatic transducer design. Finite element analysis shows that under dynamic conditions, we can achieve diaphragm deflections as much as 80 times the gap between the electrodes because of the proposed design. We compare the conventional design of electrostatically actuated audio speakers - where typical electrode separation gaps are around 60 to 100 μm and actuation voltages are in the range of 10 to 200 volts - with the proposed peripheral electrode design with an electrode separation gap of 1 μm and actuation voltage ≤100 volts. The SPL obtained is comparable to the existing designs and ranges from 40 to 60 dB at 1 kHz at 1 cm with different sizes of the micro-speakers. The efficiency achieved with the proposed design is 100 -4 % at resonance which is at least two orders higher than the typically observed value for electrostatic micro-speakers. [2020-0134]Keywords
Funding Information
- DST, MeitY under NNetra Project
This publication has 24 references indexed in Scilit:
- Electrostatic graphene loudspeakerApplied Physics Letters, 2013
- Simulations and experiments of hardening and softening resonances in a clamped–clamped beam MEMS resonatorSensors and Actuators A: Physical, 2010
- dc dynamic and static pull-in predictions and analysis for electrostatically actuated clamped circular micro-plates based on a continuous modelJournal of Micromechanics and Microengineering, 2009
- A surface micromachined offset-drive method to extend the electrostatic travel rangeJournal of Micromechanics and Microengineering, 2009
- The effect of squeeze film constriction on bandwidth improvement in interferometric accelerometersJournal of Micromechanics and Microengineering, 2008
- A silicon microspeaker for hearing instrumentsJournal of Micromechanics and Microengineering, 2004
- A novel external electrode configuration for the electrostatic actuation of MEMS based devicesJournal of Micromechanics and Microengineering, 2004
- Fabricating capacitive micromachined ultrasonic transducers with wafer-bonding technologyJournal of Microelectromechanical Systems, 2003
- CMOS-MEMS membrane for audio-frequency acoustic actuationSensors and Actuators A: Physical, 2002
- Extending the travel range of analog-tuned electrostatic actuatorsJournal of Microelectromechanical Systems, 1999