Voltage-controlled precision electronic power regulator
Author:
- 1 December 2021
- journal article
- conference paper
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 92 (12) , 124708
Abstract
The architecture of a novel electronic power regulator, which allows a set value of constant power on a wire probe to be maintained, is presented. A gain in the negative feedback loop of ≈2 · 103 allows the set power value in the series of pulses to be accurately maintained at the level of 99.95% (proximity 0.05). In order to study short term processes, the response time of the described regulator is in the order of 2 μs. The created architecture is easily scalable for various tasks, ranging from the well-known transient hot-wire method to other applications, examples of which are given in this article (unsteady heat transfer in supercritical-pressure fluids and unstable mixtures having lower critical solution temperature). A comparison of the presented controller architecture with the previously described solutions from the point of view of operational stability is given.Keywords
Funding Information
- Russian Science Foundation (19-19-00115)
This publication has 14 references indexed in Scilit:
- Comments on “Low cost and new design of transient hot-wire technique for the thermal conductivity measurement of fluids” (Appl. Therm. Eng. 105 (2016) 142)Applied Thermal Engineering, 2018
- Returning to classic conditions of THW-technique: A device for the constant heating power modeInternational Journal of Heat and Mass Transfer, 2017
- Heat transfer under high-power heating of liquids. 2. Transition from compressed to supercritical waterInternational Journal of Heat and Mass Transfer, 2014
- Investigation of not fully stable fluids by the method of controlled pulse heating. 1. Experimental approachThermochimica Acta, 2013
- Heat transfer in supercritical fluids under pulse heating regimeInternational Journal of Heat and Mass Transfer, 2012
- Historical Evolution of the Transient Hot-Wire TechniqueInternational Journal of Thermophysics, 2010
- Transient Hot Wire (THW) Method: Uncertainty AssessmentInternational Journal of Thermophysics, 2000
- Absolute steady-state thermal conductivity measurements by use of a transient hot-wire systemJournal of Research of the National Institute of Standards and Technology, 2000
- Improved hot-wire procedure for thermophysical measurements under pressureReview of Scientific Instruments, 1988
- Thermal conductivity of solids under pressure by the transient hot wire methodReview of Scientific Instruments, 1976