Surface Grain Refinement of 304L Stainless Steel by Combined Severe Shot Peening and Reversion Annealing Treatment
Open Access
Abstract
The present study proposes a novel method, i.e., combined severe shot peening (SP) and reversion annealing treatment, to grain-refine the surface layers of 304L austenitic stainless steel. Steel specimens were shot-peened at 0.7 MPa for 30 min, introducing 40% vol. α′ martensite, and then were annealed at 700 or 800 °C for different durations (30 s). As annealing reversed α′ martensite to austenite, the obtained surface layers consist of fully austenitic ultrafine grains. The smallest grain size obtained is about 500 nm at the top surface. SP elevates the microhardness to more than 500 HV. Although the grain-refined surface layers produced by the combined method are not as hard as that treated by only SP, they are harder (e.g., the specimen annealed at 700 °C for 30 s using a heating rate of 50 °C/s exhibited a peak microhardness of 400 HV) than the untreated surface layer (225 HV) due to grain refinement. Moreover, due to the absence of α′ martensite, they have higher corrosion resistance in H2SO4 solution than that treated by only SP.Keywords
Funding Information
- Postgraduate Research & Practice Innovation Program of Jiangsu Province (KYCX19_2178)
- National Natural Science Foundation of China (51705516)
This publication has 24 references indexed in Scilit:
- In-situ EBSD investigation of thermal stability of a 316L stainless steel nanocrystallized by Surface Mechanical Attrition TreatmentMaterials Letters, 2019
- Shot Peening Process Effects on Metallurgical and Mechanical Properties of 316 L Steel via: Experimental and Neural Network ModelingMetals and Materials International, 2019
- Study of the austenitic stainless steel with gradient structured surface fabricated via shot peeningMaterials Letters, 2018
- Enhanced mechanical behaviors of gradient nano-grained austenite stainless steel by means of ultrasonic impact treatmentResults in Physics, 2017
- Effect of high energy shot peening pressure on the stress corrosion cracking of the weld joint of 304 austenitic stainless steelMaterials Science and Engineering: A, 2015
- Optimization of the fatigue resistance of AISI304 stainless steel by ultrasonic impact treatmentInternational Journal of Fatigue, 2014
- Influence of surface mechanical attrition treatment (SMAT) on the corrosion behaviour of AISI 304 stainless steelCorrosion Science, 2013
- Effect of structure evolution induced by ultrasonic peening on the corrosion behavior of AISI-321 stainless steelMaterials Science and Engineering: A, 2007
- Formation of nanostructured surface layer on AISI 304 stainless steel by means of surface mechanical attrition treatmentActa Materialia, 2003
- Role of shot-peening on hydrogen embrittlement of a low-carbon steel and a 304 stainless steelJournal of Materials Science, 1991