Optimal Synergetic Control of Three-Phase/Level Boost–Buck Voltage DC-Link AC/DC Converter for Very-Wide Output Voltage Range High-Efficiency EV Charger
- 1 August 2023
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Emerging and Selected Topics in Power Electronics
- Vol. 12 (1) , 28-42
Abstract
Universal high-power three-phase mains interfaces for electric vehicle (EV) charging must provide a wide output voltage range (e.g., 200V to 800 V) and thus provide buck and boost capability. An advantageous realization combining a three-level (3-L) T-type (Vienna) boost-type PFC voltage-source rectifier (VSR) with a 3-L buck-type DC/DC converter stage is presented in this paper. For high output voltages (boost-mode), the VSR-stage operates with 3/3-PWM, i.e., continuous PWM of all three phases to regulate the output voltage while the DC/DC-stage remains clamped to avoid switching losses. For low output voltages (buck-mode), the DC/DC-stage advantageously controls the DC-link voltage according to a time-varying reference value, which allows to sinusoidally shape the currents of two mains phases, such that the VSR-stage can operate with 1/3-PWM (only one of the three bridge-legs operates with PWM at any given time) with reduced switching losses. This paper proposes a novel 2/3-PWM scheme for the output voltage transition region, where output voltages are between the buck-mode and the boost-mode. This enables loss-optimum operation (i.e., the minimum number of the VSR-stage bridge-legs operating with PWM, and with the minimum possible DC-link voltage) for any output voltage. Furthermore, this paper introduces a new synergetic control concept that ensures seamless transitions between the loss-optimum operating modes. A comprehensive experimental verification, including pre-compliance EMI measurements, using a 10-kW hardware demonstrator with a power density of 5.4 kW/dm 3 (91 W/in 3 ), a peak efficiency of 98.8% at rated power and 560V output voltage, and >98% efficiency for all operating points with >400V output voltage and more than about 50% of rated power, confirms the theoretical analyses.Keywords
This publication has 34 references indexed in Scilit:
- Comparison of Unidirectional Three- and Four-Wire-Based Boost PFC-Rectifier Topologies for Non-Isolated Three-Phase EV On-Board Chargers Under Common-Mode Aspects2021
- Three-Phase Bidirectional Buck-Boost Current DC-Link EV Battery Charger Featuring a Wide Output Voltage Range of 200 to 1000V2020
- New Synergetic Control of a 20kW Isolated VIENNA Rectifier Front-End EV Battery Charger2019
- Analysis of variation of neutral point potential in neutral-point-clamped voltage source PWM inverters2002
- A three-phase sine wave inverter system using multiple phase-shifted single-phase resonant inverters2002
- Experimental comparisons of space vector neutral point balancing strategies for three-level topologyIEEE Transactions on Power Electronics, 2001
- A comprehensive study of neutral-point voltage balancing problem in three-level neutral-point-clamped voltage source PWM invertersIEEE Transactions on Power Electronics, 2000
- Simple analytical and graphical methods for carrier-based PWM-VSI drivesIEEE Transactions on Power Electronics, 1999
- A novel three-phase utility interface minimizing line current harmonics of high-power telecommunications rectifier modulesIEEE Transactions on Industrial Electronics, 1997
- PWM technique for power MOSFET inverterIEEE Transactions on Power Electronics, 1988