Modeling and Experimental Evaluation of 1-3 Stacked Piezoelectric Transducers for Energy Harvesting
Open Access
- 16 June 2025
- journal article
- research article
- Published by MDPI AG in Journal of Composites Science
- Vol. 9 (6) , 304
Abstract
Piezoelectric energy harvesting in roadways can power distributed sensors and electronics by capturing underutilized mechanical energy from traffic. In this research, 1-3 stacked piezocomposites were developed and evaluated to determine optimal designs for multiple applications. The design of these transducers aimed at operating in a multitude of scenarios, under compressive loads (1–10 kN) at low-frequency (10 Hz) applications, intended to simulate vehicular forces. Power comparison was utilized between numerous transducers to determine the most efficient configuration for electromechanical energy conversion. Design guidelines were based on mechanical integrity, output power, active piezoelectric volume percentage, aspect ratio, and geometric factors. The forces applied in this study were reliant on the average vehicle weight. An intermediate PZT volume fraction and moderate pillar aspect ratios were found to yield the highest power output, with the stacked 1-3 composite significantly outperforming a monolithic PZT of a similar size.Keywords
Funding Information
- U.S. Department of the Navy (N00014-21-1-2857, DE-NA0004003)
- Department of Energy National Nuclear Security Administration (N00014-21-1-2857, DE-NA0004003)
- Texas Department of Transportation Project 0-6871 (N00014-21-1-2857, DE-NA0004003)
This publication has 8 references indexed in Scilit:
- Performances Investigation of Multi-Configuration Connections in Piezoelectric Energy HarvesterJournal of Vibration Engineering & Technologies, 2025
- 3D printed piezoelectric porous structure with enhanced output performance and stress-electricity response for road energy harvestingAdditive Manufacturing, 2023
- Degradation of piezoelectric device as an energy harvester under equivalent traffic stress conditionFerroelectrics, 2019
- Piezoelectric stacked transducer evaluation and comparison for optimized energy harvestingFerroelectrics, 2018
- Hysteresis Compensation and Sliding Mode Control with Perturbation Estimation for Piezoelectric ActuatorsMicromachines, 2018
- Design and Simulation of 100 kHz and 200 kHz Tri-Phasic PZT Piezoelectric TransducersIntegrated Ferroelectrics, 2015
- Stress induced domain switching of PZT in compression testsMaterials Science and Engineering: A, 2001
- Modeling 1-3 composite piezoelectrics: thickness-mode oscillationsIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 1991