Oxygen‐alloyed poly‐Si passivating contacts for high‐thermal budget c‐Si heterojunction solar cells
Open Access
- 29 September 2021
- journal article
- research article
- Published by Wiley in Progress in Photovoltaics: Research and Applications
- Vol. 30 (2) , 141-151
Abstract
Crystalline silicon solar cells with passivating contacts based on doped poly‐Si exhibit high optical parasitic losses. Aiming at minimizing these losses, we developed the oxygen‐alloyed poly‐Si (poly‐SiOx) as suitable material for passivating contacts. From passivation point of view, poly‐SiOx layers show excellent passivation quality and carrier selectivity for both n‐type (iVOC,flat = 740 mV, contact resistance ρc = 0.7 mΩ/cm2, iVOC,textured = 723 mV) and p‐type (iVOC,flat = 709 mV, ρc = 0.5 mΩ/cm2). Optically, due to the incorporation of oxygen, the absorption coefficient of poly‐SiOx becomes much lower than that of doped poly‐Si at long wavelength. Both n‐type and p‐type poly‐SiOx layers are concurrently deployed in front/back‐contacted (FBC) solar cells with a front indium tin oxide (ITO) layer to facilitate the lateral transport of carriers and minimize cell's reflection. A high cell FF of 83.5% obtained in double‐side flat FBC solar cell indicates an efficient carrier collection by these passivating contacts. An active‐area cell efficiency of 21.0% featuring JSC,EQE = 39.7 mA/cm2 is obtained in front‐side textured poly‐SiOx FBC cell, with the potential of further improvement in both VOC and FF. The optical advantage of poly‐SiOx over poly‐Si as passivating contact is also observed with a 19.7% interdigitated back‐contacted (IBC) solar cell endowed with poly‐SiOx emitter and back surface field. Compared to the reference 23.0% IBC solar cell with poly‐Si passivating contacts, the one based on poly‐SiOx passivating contacts shows higher IQE at wavelengths above 1100 nm. This indicates that for both FBC and IBC cells, poly‐SiOx passivating contacts hold potential in enhancing the cell JSC by maximizing the cell spectral response.Keywords
This publication has 47 references indexed in Scilit:
- The application of poly-Si/SiOx contacts as passivated top/rear contacts in Si solar cellsSolar Energy Materials and Solar Cells, 2017
- Passivating electron contact based on highly crystalline nanostructured silicon oxide layers for silicon solar cellsSolar Energy Materials and Solar Cells, 2016
- IBC c-Si solar cells based on ion-implanted poly-silicon passivating contactsSolar Energy Materials and Solar Cells, 2016
- Design and application of ion-implanted polySi passivating contacts for interdigitated back contact c-Si solar cellsApplied Physics Letters, 2016
- 335-W World-Record p-Type Monocrystalline Module With 20.6% Efficient PERC Solar CellsIEEE Journal of Photovoltaics, 2015
- Phosphorus-diffused polysilicon contacts for solar cellsSolar Energy Materials and Solar Cells, 2015
- Ion Implantation for Poly-Si Passivated Back-Junction Back-Contacted Solar CellsIEEE Journal of Photovoltaics, 2015
- Tunnel oxide passivated contacts as an alternative to partial rear contactsSolar Energy Materials and Solar Cells, 2014
- Contactless determination of current–voltage characteristics and minority-carrier lifetimes in semiconductors from quasi-steady-state photoconductance dataApplied Physics Letters, 1996
- Interband optical absorption in amorphous siliconJournal of Non-Crystalline Solids, 1988