Suspended solid removal efficiency of plate settlers and tube settlers analysed by CFD modelling
Open Access
- 11 April 2023
- journal article
- research article
- Published by IWA Publishing in Water Science & Technology
- Vol. 87 (9) , 2116-2127
Abstract
Removal of suspended solids from raw water is an essential process in water treatment plants. Conventional sedimentation tanks in water treatment plants occupy a large area and become expensive in urban areas. The use of plate settlers or tube settlers in sedimentation tanks to increase the efficiency and hence reduce the footprint of sedimentation tanks is an economical solution in water treatment. This study investigated the effectiveness of plate and tube settlers compared to conventional settlers in a water treatment plant. A three-dimensional Computational Fluid Dynamics (CFD) model was set up using ANSYS-CFX 17.2. Seven cases (a conventional settler, three plate settlers and three tube settlers) were analysed to compare the settler performances. The maximum removal efficiencies of all solid classes were approximately equal in plate and tube settlers with the same plate spacing and tube depth: around 100%, 67%, 28% and 9% for the solid classes with particle diameters of 41, 17, 9.5 and 5.0 µm, respectively. The settling efficiency remained unchanged with the increase of the plate settling area beyond 60% of the conventional settler area under the given tank and flow conditions. The tube cross-section shape does not affect the particle removal efficiency of a tube settler.Keywords
This publication has 9 references indexed in Scilit:
- Improvement of Suspended Solids Removal Efficiency in Sedimentation Tanks by Increasing Settling Area Using Computational Fluid DynamicsJournal of Water and Environment Technology, 2019
- Computational Fluid Dynamics Study on Attainable Flow Rate in a Lamella Settler by Increasing Inclined PlatesJournal of Water and Environment Technology, 2019
- Performance of the Tube Settler Clarification at Different Inclination Angles and Variable Flow RateMathematical Modelling in Civil Engineering, 2018
- Performance Study of Tube Settlers ModuleInternational Journal of Engineering Research and Applications, 2017
- Evaluating the Use of Tube Settlers and Lamella Plates in Increasing the Efficiency of Sedimentation TanksJournal of Applied Life Sciences International, 2016
- Modeling settling tanks for water treatment using computational fluid dynamicsJournal of Hydroinformatics, 2015
- The influence of lamellar settler in sedimentation tanks for potable water treatment — A computational fluid dynamic studyPowder Technology, 2014
- Experimental investigation of effects of baffle configurations on the performance of a secondary sedimentation tankScientia Iranica, 2011
- Effects of Inlet Position and Baffle Configuration on Hydraulic Performance of Primary Settling TanksJournal of Hydraulic Engineering, 2008