Behavior of a Rock Mass in Uplift Field Tests of Rock Anchors
Open Access
- 19 December 2023
- journal article
- research article
- Published by Springer Nature in Rock Mechanics and Rock Engineering
- Vol. 57 (4) , 2339-2364
Abstract
Rock anchors are high-capacity reinforcement measures used to stabilize large-scale infrastructures. According to the literature, they can fail in one of the four ways: (1) steel tensile failure; (2) tendon–grout interface failure; (3) grout–rock interface failure; and (4) rock mass uplift failure. Rock mass uplift field tests were performed in a limestone quarry to test this fourth failure mode. The tests were designed to induce rock mass failure around rock anchors. The ground surface heaved asymmetrically around the anchors and the pre-existing joints in the rock mass tended to open first. The seismic activity in the rock mass was greatest close to the anchor, decreasing with distance. The failure crater in the rock followed the joint sets in the rock mass, and the shape was partly controlled by the pre-existing joints. The apex angle of the failures was measured to be between 125 and 140 $$^{\circ }$$ . The horizontal stress in the rock mass increased when the anchor was pulled, indicating load arching around the anchor. The observed failure was a combination of rock mass uplift and grout–rock bond failure. The measured anchor capacity was much higher than the estimated rock mass capacity using the recommended design methods of the Norwegian Public Roads Administration.
Keywords
Funding Information
- Norges Forskningsråd (303448)
- Statens vegvesen (90503200)
- NTNU Norwegian University of Science and Technology
This publication has 19 references indexed in Scilit:
- Determination and applications of rock quality designation (RQD)Journal of Rock Mechanics and Geotechnical Engineering, 2016
- Rock engineering design of post-tensioned anchors for dams – A reviewJournal of Rock Mechanics and Geotechnical Engineering, 2015
- Stress State Analysis on a Rock Anchor RC Foundation of Wind Driven GeneratorApplied Mechanics and Materials, 2013
- Grouting of Anchors to Resist Hydrostatic Uplift at Burnley Tunnel, Melbourne, Australia2012
- Strength and failure modes of rock mass models with non-persistent jointsInternational Journal of Rock Mechanics and Mining Sciences, 2007
- Some new Q-value correlations to assist in site characterisation and tunnel designInternational Journal of Rock Mechanics and Mining Sciences, 2002
- Rock mass strength parameters mobilised in tunnelsTunnelling and Underground Space Technology, 1997
- The use of stress-strength relationships in the assessment of tunnel stabilityTunnelling and Underground Space Technology, 1996
- Design of Anchors in Horizontally Jointed RocksJournal of Geotechnical Engineering, 1984
- Design of shallow rock-anchored foundationsCanadian Geotechnical Journal, 1982