Performance of Different Cell Structure Converters A Total Systems Perspective
Authors:
- 19 October 1998
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
The objective of this effort was to develop an understanding of how different converter substrate cell structures impact tailpipe emissions and pressure drop from a total systems perspective. The cell structures studied were the following: The catalyst technologies utilized were a new technology palladium only catalyst in combination with a palladium/rhodium catalyst. A 4.0-liter, 1997 Jeep Cherokee with a modified calibration was chosen as the test platform for performing the FTP test. The experimental design focused on quantifying emissions performance as a function of converter volume for the different cell structures. The results from this study demonstrate that the 93 square cell/cm2 structure has superior performance versus the 62 square cell/cm2 structure and the 46 triangle cell/cm2 structure when the converter volumes were relatively small. However, as converter volume increases the emissions differences diminish. For this application the results also show that the higher cell density, lower mass substrates have a slight advantage in catalyst light-off. The emphasis of this study was a comparison of different cell structures, however, other factors such as thermal management, catalyst technology and air-fuel ratio control also contributed significantly to the relative performance of these systems. In conclusion, this study demonstrates the advantages of higher cell density structures to help meet future emissions challenges. In addition, this study also demonstrates that substrate support technology must be integrated with the catalyst technology, the converter packaging, and the engine management control to create a total system, which meets emissions and durability requirements.Keywords
This publication has 11 references indexed in Scilit:
- Development of the Ultra Low Heat Capacity and Highly Insulating (ULOC) Exhaust Manifold for ULEVSAE International Journal of Advances and Current Practices in Mobility, 1998
- New Ultra Thin Wall Metal Catalysts for Close-Coupled ApplicationsSAE International Journal of Advances and Current Practices in Mobility, 1998
- Development of the High Performance L4 Engine ULEV SystemSAE International Journal of Advances and Current Practices in Mobility, 1998
- Fatigue and Performance Data for Advanced Thin Wall Ceramic CatalystsSAE International Journal of Advances and Current Practices in Mobility, 1998
- Design of a Dual Wall Air Gap Exhaust ManifoldSAE International Journal of Advances and Current Practices in Mobility, 1998
- Demonstration of High Temperature Durability for Oval Ceramic Catalytic Converters-2SAE International Journal of Advances and Current Practices in Mobility, 1998
- Interaction Between Gasoline Properties and Engine Management System and Effects on 3-Way Catalyst EfficiencySAE International Journal of Advances and Current Practices in Mobility, 1997
- Substrate Effects on Light-Off - Part II Cell Shape ContributionsSAE International Journal of Advances and Current Practices in Mobility, 1997
- Design Development of High Temperature Manifold Converter Using Thin Wall Ceramic SubstrateSAE International Journal of Advances and Current Practices in Mobility, 1997
- Advanced Ceramic Substrate: Catalytic Performance Improvement by High Geometric Surface Area and Low Heat CapacitySAE International Journal of Advances and Current Practices in Mobility, 1997