Influences of Atmospheric Humidity on Sliding Speed Characteristics of Dry Sliding Phenomena
Authors:
Open Access
- 31 October 2023
- journal article
- conference paper
- Published by Japanese Society of Tribologists in Tribology Online
- Vol. 18 (6) , 339-352
Abstract
The effect of adsorbed water layers in sliding phenomena has been widely recognized, but it has yet to be explained thoroughly after many years of research. Previous researches tend to explain the phenomena from chemical and qualitative viewpoints, thus physical viewpoint approaches with quantitative evidence are necessary to complement the previous research works. Studies were done to estimate the thickness of adsorbed water layers in recent years to obtain quantitative evidence of the effect of adsorbed water layers. It was found that the thickness of the adsorbed water layer derived from atmospheric humidity could provide physical influences on sliding phenomena. The hypothesis in this study based on the Stribeck curve is; the friction coefficient may decrease significantly with the increase of sliding speed at high relative humidity (RH) compared to low RH. To verify the hypothesis, a pair of JIS SUS304 austenitic stainless steel balls were scratched against each other horizontally with a vertical overlapping distance of 80 µm at sliding speeds of 20, 200, and 2000 µm·s−1 in RH of 5, 55, and 95%. The experimental results supported the hypothesis as the friction coefficient for medium to high RH decreased significantly with increasing sliding speed while the friction coefficient decreases slightly at low RH. The friction coefficient decreases significantly at high sliding speed and RH. The possible physical effects of the adsorbed water layers were suggested.Keywords
This publication has 22 references indexed in Scilit:
- The Effect of Relative Humidity and Roughness on the Friction Coefficient under Horizontal VibrationThe Open Mechanical Engineering Journal, 2008
- Effect of relative humidity on the unlubricated wear of metalsWear, 2006
- Evolution of the Adsorbed Water Layer Structure on Silicon Oxide at Room TemperatureThe Journal of Physical Chemistry B, 2005
- Influence of Lubricant Additive and Surface Texture on the Sliding Friction Characteristics of Steel under Varying Speeds Ranging from Ultralow to ModerateTribology Transactions, 2005
- The influence of atmospheric humidity and grain size on the friction and wear of AISI 304 austenitic stainless steelMaterials Letters, 2003
- The effect of relative humidity on friction and pull-off forces measured on submicron-size asperity arraysWear, 2000
- On the repeatability of friction and wear results and on the influence of humidity in oscillating sliding tests of steel-steel pairingsWear, 1995
- A review of the influence of environmental humidity and water on friction, lubrication and wearTribology International, 1990
- The effects of the surrounding atmosphere on the friction and wear of alumina, zirconia, silicon carbide and silicon nitrideWear, 1989
- Friction and Wear of MaterialsJournal of Applied Mechanics, 1966