Energy-Harvesting Piezoelectric-Powered CMOS Series Switched-Inductor Bridge
- 8 October 2018
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 34 (7) , 6489-6497
Abstract
Tiny piezoelectric transducers transform a very small fraction of ambient energy into electrical power. Power losses and breakdown voltages unfortunately limit how much of this power reaches the microsystem. The piezoelectric harvester presented here operates at the maximum power point (MPP) without the separate MPP stage that typical piezoelectric harvesters need. As a result, the system loses less power and occupies less space. Plus, with only four transistors, the charger increases the voltage with which the piezoelectric current generates power. This way, the harvester draws more power from vibrations. By pre-charging the transducer between half cycles, the 0.81-1.2- $\mu$ m CMOS system outputs 0.7-49 $\mu$ W of the 1.2-55 μW that a vibrating 16.8-nF transducer avails at 120 Hz. This is up to 6.8 $\times$ more power than a lossless diode bridge can harness and as much as the best recycling bridge can output, but with four fewer power switches and without a separate maximum power-point stage.
Keywords
This publication has 34 references indexed in Scilit:
- Achieving High Efficiency Under Micro-Watt Loads with Switching Buck DC–DC ConvertersJournal of Low Power Electronics, 2009
- Powering MEMS portable devices—a review of non-regenerative and regenerative power supply systems with special emphasis on piezoelectric energy harvesting systemsSmart Materials and Structures, 2008
- An improved analysis of the SSHI interface in piezoelectric energy harvestingSmart Materials and Structures, 2007
- Energy harvesting vibration sources for microsystems applicationsMeasurement Science and Technology, 2006
- Accurate electrical battery model capable of predicting runtime and I-V performanceIEEE Transactions on Energy Conversion, 2006
- Piezoelectric Micro-Power Generation Interface CircuitsIEEE Journal of Solid-State Circuits, 2006
- A 950-MHz Rectifier Circuit for Sensor Network Tags With 10-m DistanceIEEE Journal of Solid-State Circuits, 2005
- A study of low level vibrations as a power source for wireless sensor nodesComputer Communications, 2003
- Adaptive piezoelectric energy harvesting circuit for wireless remote power supplyIEEE Transactions on Power Electronics, 2002
- CMOS tapered bufferIEEE Journal of Solid-State Circuits, 1990