Preparation of Wear-Resistant Coating on Ti6Al4V Alloy by Cold Spraying and Plasma Electrolytic Oxidation
Open Access
Abstract
In order to improve the wear resistance of Ti6Al4V alloy, the alloy was first coated with alumina-reinforced aluminum coating (CS-coating) by cold spraying, and then the alloy with CS-coating was processed by plasma electrolytic oxidation (PEO) under unipolar mode and soft sparking mode, respectively, to prepare wear-resistant PEO coatings. For comparison, Ti6Al4V alloy without CS-coating was also subjected to PEO treatment. The microstructure, phase composition, hardness, and wear resistance of the PEO coatings formed on Ti6Al4V alloy with and without CS-coating were investigated. The results revealed that PEO coatings formed on Ti6Al4V alloy with CS-coating under soft sparking mode contained more α-Al2O3, possessed larger thickness, more compact microstructure, and higher microhardness than that formed under unipolar mode. The PEO coating formed on Ti6Al4V substrate was mainly composed of TiO2 and had pores and cracks. Among all these coatings, PEO coating formed on Ti6Al4V alloy with CS-coating under soft sparking mode exhibited the best wear resistance with a wear rate of 1.18 × 10−5 mm3/(Nm), which was only 15.28% of that of the Ti6Al4V substrate. The investigation indicated that the combination of cold spraying and PEO under soft sparking mode is a promising technique for improving the wear resistance of titanium alloy.Keywords
Funding Information
- Special Research Project of Shaanxi Provincial Department of Education (18JK0475)
- Shaanxi Provincial Natural Science Foundation (2020JM-493)
This publication has 40 references indexed in Scilit:
- Increasing the tribological performances of Ti–6Al–4V alloy by forming a thin nanoporous TiO2 layer and hydroxyapatite electrodeposition under lubricated conditionsTribology International, 2014
- Phase transformation in plasma electrolytic oxidation coatings on 6061 aluminum alloySurface and Coatings Technology, 2014
- Cold spray coating: review of material systems and future perspectivesSurface Engineering, 2014
- One-step preparation of TiO2/MoS2 composite coating on Ti6Al4V alloy by plasma electrolytic oxidation and its tribological propertiesSurface and Coatings Technology, 2013
- Evaluation of micromechanical behaviour of plasma electrolytic oxidation (PEO) coatings on Ti–6Al–4VSurface and Coatings Technology, 2010
- Spectroscopic study of electrolytic plasma and discharging behaviour during the plasma electrolytic oxidation (PEO) processJournal of Physics D: Applied Physics, 2010
- Several plasma diffusion processes for improving wear properties of Ti6Al4V alloyWear, 2009
- Integrated characterization of cold sprayed aluminum coatingsActa Materialia, 2007
- An overview on the use of titanium in the aerospace industryMaterials Science and Engineering: A, 1996
- Contact and Rubbing of Flat SurfacesJournal of Applied Physics, 1953