Sensitivity and non-linearity study and performance enhancement in bossed diaphragm piezoresistive pressure sensor
- 1 June 2015
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Abstract
This paper describes a comparative study of sensitivity and non-linearity of conventional and bossed diaphragm piezoresistive pressure sensor along with a performance enhanced design. The proposed structures take into consideration corner compensation to avoid distortion of the mesa structure during fabrication of bossed diaphragm structure using wet bulk micromachining. Optimum piezoresistors locations are calculated with the help of simulations carried out using finite element method (FEM) based tool COMSOL © Multiphysics. Since the sensitivity and non-linearity of conventional and bossed diaphragm structures showed a linear trend, empirical formulae are proposed using linear fit for quick and approximate calculation of sensitivity and non-linearity for a particular sensor structure. It is observed that high stress regions are also present near the boss - diaphragm interface and hence a design with piezoresistors placed at these regions is also proposed. This design is found to be enhancing the performance of piezoresistive pressure sensor compared to the conventional piezoresistor placement.Keywords
This publication has 9 references indexed in Scilit:
- Design principles and considerations for the ‘ideal’ silicon piezoresistive pressure sensor: a focused reviewMicrosystem Technologies, 2014
- Experimental study and analysis of corner compensation structures for CMOS compatible bulk micromachining using 25 wt% TMAHMicroelectronics Journal, 2011
- What is the Young's Modulus of Silicon?Journal of Microelectromechanical Systems, 2010
- Review: Semiconductor Piezoresistance for MicrosystemsProceedings of the IEEE, 2009
- A Novel Pressure Microsensor With 30-$\mu \hbox{m}$-Thick Diaphragm and Meander-Shaped Piezoresistors Partially Distributed on High-Stress Bulk Silicon RegionIEEE Sensors Journal, 2007
- lang1 0 0rang bar corner compensation for CMOS compatible anisotropic TMAH etchingJournal of Micromechanics and Microengineering, 2006
- Piezoresistive sensing2005
- Simulation of circular silicon pressure sensors with a center boss for very low pressure measurementIEEE Transactions on Electron Devices, 1989
- Piezoresistance Effect in Germanium and SiliconPhysical Review B, 1954