Morphological and crystallinity differences in nitrogen-doped carbon nanotubes grown by chemical vapour deposition decomposition of melamine over coal fly ash
Open Access
- 8 August 2016
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 6 (80) , 76773-76779
Abstract
Millions of tons of coal fly ash (CFA) are produced each year in thermoelectric coal powered stations as a waste-product. Until recently few researchers have endeavored to use CFA as a catalyst in the formation of carbon nanomaterials (CNMs). In this study a two-stage tube furnace was used to synthesize N-doped carbon nanotubes (NCNTs) by chemical vapor deposition using melamine as the source of nitrogen and carbon, with CFA as a catalyst, at temperatures ranging from 800 to 900 °C. The masses of the NCNTs formed were found to have increased with increased synthesis temperature. The morphology and crystallinity of the NCNTs along with the amount of nitrogen incorporated into these were found to vary with the synthesis temperature. NCNTs synthesized at 800 °C were found to be typical multiwalled carbon nanotubes by transmission electron microscopy, whereas those at 850 and 900 °C were found to be chain-like and bamboo-like compartmentalised nanotubes respectively. The NCNTs synthesized at 800 °C were found to contain the least incorporation of nitrogen by elemental analysis and were the most crystalline (as determined by using the IG/ID ratio and the G-band position from laser Raman spectroscopy), whereas those at 850 °C were the least crystalline but had the highest incorporation of nitrogen. NCNTs synthesised at 800 °C were the most thermally stable, whereas those synthesized at 850 °C were the least stable. NCNTs synthesized at 900 °C had a crystallinity, thermal stability and nitrogen content which lay between the other two.Keywords
Funding Information
- National Research Foundation (88076)
This publication has 41 references indexed in Scilit:
- Influence of surface area properties on mercury capture behaviour of coal fly ashes from some Bulgarian power plantsInternational Journal of Coal Geology, 2013
- A review of the multi-component utilisation of coal fly ashFuel, 2012
- Applied investigation on the interaction of hazardous elements binding on ultrafine and nanoparticles in Chinese anthracite-derived fly ashScience of The Total Environment, 2012
- A review on the utilization of fly ashProgress in Energy and Combustion Science, 2010
- Potential fly-ash utilization in agriculture: A global reviewProgress in Natural Science: Materials International, 2009
- Synthesis of Multiwalled Carbon Nanotubes on Fly Ash Derived CatalystsEnvironmental Science & Technology, 2009
- Effect of synthesis parameters on the mechanical properties of fly ash-based geopolymersColloids and Surfaces A: Physicochemical and Engineering Aspects, 2007
- Methods for Characterization of Composition of Fly Ashes from Coal-Fired Power Stations: A Critical OverviewEnergy & Fuels, 2005
- Selective catalytic reduction of NO by ammonia with fly ash catalyst☆Fuel, 2003
- Adsorption and photocatalysis of colour removal from waste water using flyash and sunlightCatalysis Communications, 2001