Effects of Added Clay on the Properties of Freeze‐Casted Composites of Silica Nanoparticles
Authors:
- 9 April 2009
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 92 (4) , 916-921
Abstract
An experimental study was performed to investigate the effects of added clay particles on the structure and properties of porous, freeze‐dried composites produced from silica nanoparticles. The sol–gel transition of the silica suspension arrests the sedimentation of the dense clay platelets to produce a gel, containing large clay particles dispersed throughout. No chemical additives other than sodium chloride were needed to cause the gelation. Dry composites were obtained by subjecting the gelled suspensions to rapid freezing in one of the following ways: submersion in liquid nitrogen or liquid propane, or exposure to low‐temperature refrigeration. Frozen samples were then sublimated under vacuum to remove the water. Scanning electron microscope images of the dried composites showed a porous material whose pore sizes decrease with an increasing rate of freezing. The dependence on freeze rate suggests that the porous structure is the result of ice formation. Addition of the clay particles significantly increases the rate of gel formation. Furthermore, the strength of the clay/nanoparticle composites, as measured by normal compression tests, was substantially greater than that of a similar material made with only silica nanoparticles. Finally, BET surface area analysis shows a decreasing surface area with increasing volume fraction of clay at a constant volume fraction of silica.Keywords
This publication has 31 references indexed in Scilit:
- Microstructural Evolution of Nanoparticle Aqueous Colloidal Suspensions During Freeze CastingJournal of the American Ceramic Society, 2007
- Fabrication of Functionally Graded and Aligned Porosity in Thin Ceramic Substrates With the Novel Freeze–Tape‐Casting ProcessJournal of the American Ceramic Society, 2007
- Influence of Freezing Temperature on Product Parameters of Solid Dosage Forms Prepared via the Freeze‐Casting TechniqueChemical Engineering & Technology, 2007
- Fabrication of Porous Alumina Sintered Bodies by a Gelate-Freezing MethodJournal of the Ceramic Society of Japan, 2005
- Preparation of Porous TiO2 Cryogel Fibers through Unidirectional Freezing of Hydrogel Followed by Freeze-DryingChemistry of Materials, 2004
- Pecan Texture as Affected by Freezing Rates, Storage Temperature, and Thawing RatesJournal of Food Science, 1999
- Freeze-formed silica fibresNature, 1980
- On the fixation of water in diverse fireInternational Journal of Heat and Mass Transfer, 1966
- ICE CRYSTAL GROWTH DURING THE RAPID FREEZING OF TISSUESJournal of Cell Biology, 1956
- Adsorption of Gases in Multimolecular LayersJournal of the American Chemical Society, 1938