Modelling and investigating the impact of EDM parameters on surface roughness in EDM of Al/Cu/Ni Alloy
- 13 July 2020
- journal article
- research article
- Published by Taylor & Francis in Australian Journal of Mechanical Engineering
- Vol. 20 (5) , 1226-1239
Abstract
The paper presents the prediction of surface quality during the electro-discharge machining (EDM) of aluminium-based alloy. The composition consists of Aluminium, copper, nickel (Al/Cu/Ni) alloy. The techniques like dimensional exponential model (DEM), response surface-based modelling (RSM), and adaptive neuro-fuzzy inference based system (ANFIS) were employed to analyse the EDM process. Response variable i.e. Surface characteristic measure in terms of roughness (Ra) is the dependent parameter. Experimental analysis was done using Taguchi’s L18 mixed OA’s i.e. orthogonal-array by considering the process parameters namely variation in the material composition (CP), pulse-on-time(TON), pulse-off- time(TOFF) and input current(IP). Analysis of variances (ANOVA) has been employed out to identify the significant process parameters and their impact over surface characteristics. Models based on the DEM and RSM were developed to analyse the surface characteristics or roughness of the Al/Cu/Ni alloy. The experimental result proves the commitment of all three approaches to represent the process effectually. The correlation coefficient (R2) between the experimental and the DEM, RSM, and ANFIS predicted roughness was 0.830626, 0.995649, and 0.999958 respectively. This value shows the dominance of the ANFIS technique over the DEM and the RSM.Keywords
This publication has 22 references indexed in Scilit:
- An investigation on the feasibility of fused deposition modelling process in EDM electrode manufacturingCIRP Journal of Manufacturing Science and Technology, 2019
- Clustered ANFIS weighing models for sweet lime (Citrus limetta) using computer vision systemJournal of Food Process Engineering, 2019
- Investigating the surface integrity of aluminium based composites machined by EDMDefence Technology, 2019
- Effects of surface layer of AISI 304 on micro EDM performancePrecision Engineering, 2019
- Comparison of Micro-EDM Characteristics of Inconel 706 between EDM Oil and an Al Powder-Mixed DielectricAdvances in Materials Science and Engineering, 2019
- Modeling and prediction of WEDM performance parameters for Al/SiCp MMC using dimensional analysis and artificial neural networkEngineering Science and Technology, an International Journal, 2019
- Analysis of Machining Parameters in WEDM of Al/SiCp20 MMC Using Taguchi-Based Grey-Fuzzy ApproachModelling and Simulation in Engineering, 2019
- Classification and weighing of sweet lime (Citrus limetta) for packaging using computer vision systemJournal of Food Measurement and Characterization, 2019
- Modeling and analysis of titanium alloy in wire-cut EDM using Grey relation coupled with principle component analysisAustralian Journal of Mechanical Engineering, 2016
- Modeling and optimization of parameters for minimizing surface roughness and tool wear in turning Al/SiCp MMC, using conventional and soft computing techniquesAdvances in Production Engineering & Management, 2015