Development of novel intermetallic joints using thin film indium based solder by low temperature bonding technology for 3D IC stacking
Authors:
- 1 May 2009
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 05695503,p. 333-338
Abstract
Low temperature bonding technology was developed using In-alloy on Au at a low temperature below 200 °C forming robust intermetallics (IMC) joints with high remelting temperature (≫300°C), so that after bonding, the IMC joints can withstand the subsequent processes without any degradation. Process parameters on the solder joint were optimized extensively in bonding and annealing process (temperature, time, and pressure). The joint fabricated at an optimal condition, which is 180°C for 45sec followed by annealing at 120°C for 12hrs, was evaluated in terms of microstructure and compositional observations by means of scanning electron microscope (SEM) and transmittance electron microscope (TEM). As a result, it was confirmed that the joint was completely occupied with the Au-In based IMC phases. And the re-melting temperature was measured as above 400°C by using Differential Scanning Calorimetery (DSC) and Thermo-Mechanical Analysis (TMA). This IMC joint showed a high bonding shear strength (≫20MPa) and a low electrical resistance (≪100mΩ). Based on this study, the 3 stacked dice with 8×8 mm2 dies with ∼1700 I/Os of 80um solder bumps were fabricated in a chip to chip stacking method. It showed uniform bonding all over the die in each layer and the high bonding strength of ∼40 MPa and passed the 3 times reflow test at 260 °C. The IMC joint reliability was examined. After going through the multiple reflows at 260°C, the bonded samples exhibited no delaminating and no changes in the bonding strength and the electrical resistance.Keywords
This publication has 12 references indexed in Scilit:
- Development of low temperature bonding using in-based solders2008
- Self-Assembly Process for Chip-to-Wafer Three-Dimensional Integration2007
- 3D Chip Stacking Technology with Low-Volume Lead-Free Interconnections2007
- Three-dimensional wafer stacking via Cu-Cu bonding integrated with 65-nm strained-Si/low-k CMOS technologyIEEE Electron Device Letters, 2006
- Vertical System Integration by Using Inter-Chip Vias and Solid-Liquid Interdiffusion BondingJapanese Journal of Applied Physics, 2004
- Micro Cu Bump Interconnection on 3D Chip Stacking TechnologyJapanese Journal of Applied Physics, 2004
- Thermodynamic modeling of the Au-In-Sn systemJournal of Electronic Materials, 2003
- Current Status of Research and Development for Three-Dimensional Chip Stack TechnologyJapanese Journal of Applied Physics, 2001
- Microstructure examination of copper wafer bondingJournal of Electronic Materials, 2001
- Interfacial reactions between liquid indium and Au-deposited substratesJournal of Electronic Materials, 2000