Effect of 3-Mercaptopropyltriethoxysilane Modified Illite on the Reinforcement of SBR
Open Access
Abstract
To achieve the sustainable development of the rubber industry, the substitute of carbon black, the most widely used but non-renewable filler produced from petroleum, has been considered one of the most effective ways. The naturally occurring illite with higher aspect ratio can be easily obtained in large amounts at lower cost and with lower energy consumption. Therefore, the expansion of its application in advanced materials is of great significance. To explore their potential use as an additive for reinforcing rubber, styrene butadiene rubber (SBR) composites with illites of different size with and without 3-mercaptopropyltriethoxysilane (KH580) modification were studied. It was found that the modification of illite by KH580 increases the K-illite/SBR interaction, and thus improves the dispersion of K-illite in the SBR matrix. The better dispersion of smaller size K-illite with stronger interfacial interaction improves the mechanical properties of SBR remarkably, by an increment of about nine times the tensile strength and more than ten times the modulus. These results demonstrate, except for the evident effect of particle size, the great importance of filler–rubber interaction on the performance of SBR composites. This may be of great significance for the potential wide use of the abundant naturally occurring illite as substitute filler for the rubber industry.Keywords
Funding Information
- Foundation of Key Laboratory of Rubber-Plastics (KF2020010)
- Ministry of Education/Shandong Provincial Key Laboratory of Rubber-plastics (KF2020010)
- Qingdao University of Science and Technology (KF2020010)
This publication has 51 references indexed in Scilit:
- Influence of Crosslink Density on Mechanical Properties of Natural Rubber VulcanizatesJournal of Macromolecular Science, Part B, 2011
- The Effects of Silanized Ultrafine Silica on the Curing Characteristics, Tensile Properties, and Morphological Study of Natural Rubber CompoundsPolymer-Plastics Technology and Engineering, 2011
- Polymer Dynamics in Polyurethane/clay Nanocomposites Studied by Dielectric and Thermal TechniquesJournal of Macromolecular Science, Part B, 2010
- Preparation and mechanical properties of exfoliated mica-polyamide 6 nanocomposites using sericite micaApplied Clay Science, 2009
- New Age of Polymer Nanocomposites Containing Dispersed High-Aspect-Ratio Silicate NanolayersChemistry of Materials, 2008
- Surface modification of clays and clay–rubber compositeApplied Clay Science, 1999
- Effect of Humidity and Water Content on the Cure Behavior of a Natural-Rubber Accelerated Sulfur CompoundRubber Chemistry and Technology, 1992
- Alteration of smectites by treatments with hydrochloric acid and sodium carbonate solutionsApplied Clay Science, 1990
- Filler Choices in the Rubber IndustryRubber Chemistry and Technology, 1982
- The Nature of IlliteClays and clay minerals (National Conference on Clays and Clay Minerals), 1964