Thermal performance of ETICS, energy activated with PCM and PV
Authors:
Open Access
- 1 November 2021
- conference paper
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 2069 (1)
Abstract
Installing photo-voltaic (PV) panels on building façades is a growing tendency that helps to achieve both newly built and renovated nearly zero energy buildings. A novel approach to building active facades is to use a phase change material (PCM) behind the flexible PV. The PCM stabilises the PV’s temperature which can lead to an increase in energy production and cuts down the temperature peaks to avoid damage. In this study, the thermal performance of an En-ActivETICS wall was modelled in three different locations across Europe. The model was validated against on-site temperature measurements. The efficiency of the PV was calculated and an optimal PCM thickness and melting temperature were selected. The results show that annual energy production of the PV panel could increase between 2% (in Lodz) to 5% (in Madrid) using a 40mm-thick PCM. The optimal PCM melting temperatures for a certain climate should be chosen as 0 to 10 degrees below maximum air temperature in summer. The maximum peak PV temperatures could be reduced by ca. 20 K (from ∼90 to ∼70°C). Reasonable way to fix the stainless steel casing to the wall would be with four stainless steel anchor bolts – that gives 78% or 93% efficiency in case of EPS or PIR thermal insulation, respectively.Keywords
This publication has 8 references indexed in Scilit:
- The effect of temperature, humidity and mechanical properties on crack formation on external thin plasters of ETICSJournal of Physics: Conference Series, 2021
- Attenuation of Temperature Fluctuations on an External Surface of the Wall by a Phase Change Material-Activated LayerApplied Sciences, 2017
- Application of a BIPV to cover net energy use of the adjacent office roomManagement of Environmental Quality: An International Journal, 2016
- Positioning of an isothermal heat storage layer in a building wall exposed to the external environmentJournal of Building Performance Simulation, 2015
- A heat transfer model of a PV panel integrated with a “Rainscreen Cladding System”2014
- The effect of using two PCMs on the thermal regulation performance of BIPV systemsSolar Energy Materials and Solar Cells, 2011
- Phase change materials for limiting temperature rise in building integrated photovoltaicsSolar Energy, 2006
- A novelty Bayesian method for unsupervised learning of finite mixture models2005