Recycling composite piles from oil and gas infrastructure into secondary feedstock for additive manufacturing
Open Access
- 30 October 2026
- journal article
- Published by Industrial University of Tyumen in Oil and Gas Studies
- No. 5,p. 177-191
Abstract
The expanding use of polymer composites in infrastructure calls for recycling routes after the end of service. This study evaluates mechanically ground material from a hybrid basalt/glass-fibre composite pile as a filler for acrylonitrile butadiene styrene (ABS) filament and three-dimensional printing. Formulations containing 0, 10, 20 and 30 wt.% recyclate of a 0.10–0.20 mm sieve fraction were used to print two tensile and three three-point-bending specimens per formulation. The printing nozzle temperature was 260 °C. Mean maximum tensile stress decreased from 44.21 MPa for unfilled ABS to 35.49, 32.35 and 20.00 MPa, while flexural stress decreased from 79.58 to 70.46, 58.88 and 43.80 MPa, respectively. Flexural modulus remained within 2.60–2.77 GPa. At 30 wt.%, filament brittleness, winding difficulties and intermittent extrusion-nozzle clogging limited continuous filament length to 10 m. Formulations containing 10–20 wt.% recyclate warrant further development for auxiliary products whose intended use permits reduced mechanical performance. The results support further optimization of particle classification and processing conditions but do not establish a universally optimal formulation.Keywords
This publication has 26 references indexed in Scilit:
- Life Cycle Assessment of Glass Fibre Recovery from Waste Composites Using PressolysisWaste and Biomass Valorization, 2025
- Recycling polymer composite granulate/regrind using big area additive manufacturingComposites Part B: Engineering, 2023
- Recycling of thermosetting composites for wind blade applicationAdvanced Industrial and Engineering Polymer Research, 2021
- Mechanical and thermal study of 3D printing composite filaments from wind turbine wastePolymer Composites, 2021
- A review on the recycling of waste carbon fibre/glass fibre-reinforced composites: fibre recovery, properties and life-cycle analysisSN Applied Sciences, 2020
- Recycling of fiberglass wind turbine blades into reinforced filaments for use in Additive ManufacturingComposites Part B: Engineering, 2019
- Technology readiness level assessment of composites recycling technologiesJournal of Cleaner Production, 2016
- Improvement of the mechanical properties of glass fibre reinforced plastic waste powder filled concreteConstruction and Building Materials, 2010
- Successful closed-loop recycling of thermoset compositesComposites Part A: Applied Science and Manufacturing, 2009
- Recycling technologies for thermoset composite materials—current statusComposites Part A: Applied Science and Manufacturing, 2006