Characterization of the metal–insulator interface of field-effect chemical sensors
- 15 June 2003
- journal article
- research article
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 93 (12) , 9760-9768
Abstract
The metal–insulator interface of hydrogen-sensitive metal–insulator–semiconductor capacitors, with as the insulator and Pt as the metal contact, has been studied. The thin Pt films were prepared in ultrahigh vacuum by electron beam evaporation and dc magnetron sputtering. Deposition parameters were substrate temperature and sputtering pressure. The hydrogen responses of the differently prepared devices were measured in a semi-inert ambient (and used as a measure of the concentration of available adsorption sites for hydrogen at the interface). A large variation of responses was found for differently prepared sensors, and the magnitude of the response was found to increase for decreasing bonding strength between the Pt film and the substrate, as determined by scratch adhesion measurements. The bonding strength was controlled via the energetics of the Pt deposition flux. The largest interfacial roughness, from cavities between noncoalesced metal grains, and the poorest adhesion, was obtained by a reduced surface diffusion during growth and incomplete coalescence of the metal grains on the oxide surface as studied by transmission electron microscopy and atomic force microscopy. From x-ray photoelectron spectroscopy studies it was concluded that no chemical bonds were formed between Pt and It is inferred that the hydrogen active in the sensor response is adsorbed on the oxide side of the interface in a spillover process. The difference in hydrogen response between differently prepared devices can be explained by a difference in concentration of available adsorption sites giving rise to a detectable dipole moment, on the oxide due to a blocking by Pt atoms in contact with the oxide. Thus, the concentration of Pt atoms in contact with the oxide affects both the hydrogen response and the metal–oxide adhesion.
Keywords
This publication has 22 references indexed in Scilit:
- Experimental evidence for a dissociation mechanism in NH3 detection with MIS field-effect devicesSensors and Actuators B: Chemical, 2003
- Thin oxide films as surface modifiers of MIS field effect gas sensorsSensors and Actuators B: Chemical, 2002
- Difference in hydrogen sensitivity between Pt and Pd field-effect devicesJournal of Applied Physics, 2002
- Hydrogen Sensing Mechanisms of Metal−Insulator InterfacesAccounts of Chemical Research, 1998
- A model of the Temkin isotherm behavior for hydrogen adsorption at Pd–SiO2 interfacesJournal of Applied Physics, 1997
- Chemical sensors with catalytic metal gatesJournal of Vacuum Science & Technology A, 1996
- Contribution of the van der Waals forces to the work of adhesion at metal / oxide interfacesJournal of Adhesion Science and Technology, 1996
- Adhesion of advanced overlay coatings: mechanisms and quantitative assessmentSurface and Coatings Technology, 1995
- The van der Waals contribution to the adhesion energy at metal-oxide interfacesSurface Science, 1994
- Electronic structure of a metal-insulator interface: Towards a theory of nonreactive adhesionPhysical Review B, 1991