Influence of elevated Co and Ti levels on polycrystalline powder processed Ni-base superalloy
- 1 December 2014
- journal article
- research article
- Published by SAGE Publications in Materials Science and Technology
- Vol. 30 (15) , 1853-1861
Abstract
The influences of elevated Co and Ti levels on the mechanical properties of the Ni-base superalloy RR1000 have been investigated. Following heat treatment, the modified alloys had the typical γ–γ′ microstructure, with γ′ precipitate sizes comparable to similarly heat treated RR1000, but with a slightly higher volume fraction. The modified alloys exhibited a higher proof stress than RR1000 across the entire 20 to 800°C temperature range investigated. Superior creep rupture lives, when compared to RR1000, were observed in the modified alloys at 700°C, but not at 750°C, where extensive precipitation of topologically close packed σ phase occurred on the grain surfaces. The formation of this deleterious phase was linked to Cr and Mo enrichment of the γ matrix, caused by the elevated Co and Ti additions.Keywords
This publication has 28 references indexed in Scilit:
- Microstructural Evolution and Mechanical Properties of a Ni-Based Superalloy, TMW-4Metallurgical and Materials Transactions A, 2009
- Phase constituents in Ni–Al–Co–Ti quaternary alloysIntermetallics, 2008
- The evolution of η phase in Ni–Co base superalloysMaterials Science and Engineering: A, 2008
- Phase Constituents and Compressive Yield Stress of Ni-Co Base AlloysMATERIALS TRANSACTIONS, 2008
- Phase stability and yield stress of Ni-base superalloys containing high Co and TiMetallurgical and Materials Transactions A, 2006
- New Ni–Co-base disk superalloys with higher strength and creep resistanceScripta Materialia, 2006
- Microstructure and yield strength of UDIMET 720LI alloyed with Co-16.9 Wt Pct TiMetallurgical and Materials Transactions A, 2005
- Creep behaviour and microstructure of Ni-Cr base alloysMetal Science, 1984
- Effect of gamma-gamma prime mismatch, volume fraction gamma prime, and gamma prime morphology on elevated temperature properties of Ni, 20 Cr, 5.5 Mo, Ti, Al alloysMetallurgical Transactions, 1971
- Strengthening Mechanisms in γ′ Precipitating AlloysMetal Science Journal, 1970