Compressible flow characteristics in bent duct with constant flow section
Authors:
- 13 September 2020
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part G: Journal of Aerospace Engineering
- Vol. 235 (7) , 745-757
Abstract
The components with large curvature features are widely applied in aero-engines. Complex flow features are induced due to large curvature under high-subsonic even transonic incoming flow condition. In this study, the formation mechanisms of local acceleration in bent duct are investigated. To this end, the cold fluid test of a 60° bent duct with constant flow section was conducted. The surface static pressures and the schlieren flow visualizations were obtained. Then the three-dimensional numerical simulations based on the experimental model were computed using computational fluid dynamics software. The simulations were conducted using five different turbulence models to compare with the experimental data. The validation study shows that the shear stress transfer (SST) κ-ω turbulence model is suitably used for the simulations. Results show that three different flow situations were shown for the bent duct at diverse nozzle pressure ratios (NPRs). One situation was shown by the case at NPR = 1.5, in which the whole flow field is subsonic, and just two jet edges are shown by the schlieren images. One situation was shown by the case at NPR = 1.8, in which a local supersonic region is induced near the lower wall at the hind side of the bent section, and a small shock wave is observed. The other one situation was shown by the cases at NPR = 2.0, 2.5 and 3.0, in which the air flow in the whole passage reaches supersonic speeds and an oblique shock wave is shown for each case.Keywords
This publication has 10 references indexed in Scilit:
- Flow Characteristics of Double Serpentine Convergent Nozzle With Different Inlet ConfigurationJournal of Engineering for Gas Turbines and Power, 2018
- Hot Streak Characterization in Serpentine Exhaust Nozzles2016
- Influences of Design Parameters on a Double Serpentine Convergent NozzleJournal of Engineering for Gas Turbines and Power, 2016
- Numerical Predictions of Scarfing on Performance of S-Shaped Nozzle with Asymmetric LobeJournal of Propulsion and Power, 2015
- Reynolds-Stress Model Flow Prediction in Aircraft-Engine Intake Double-S-Shaped DuctJournal of Aircraft, 2010
- Internal Flow2004
- Navier-Stokes analysis of three-dimensional S-ductsJournal of Aircraft, 1993
- Application of computational fluid dynamics to complex inlet ducts1985
- Comparison of experimental and computational compressible flow in a S-duct1984
- Measurements of compressible secondary flow in a circular S-duct1983