Finite Element Simulation of Alloyed Steel (20MnCr5) in Extrusion Process Using Deform 3D Software
Authors:
- Tareque HasanTHTareque Hasan
- Safayet HossainSHSafayet Hossain
- Rotan Kumar SahaRSRotan Kumar Saha
- Nazmul HasanNHNazmul Hasan
- M TouhiduzzamanMTM Touhiduzzaman
- M MamunM Mamun
- Rafiqul IslamRIRafiqul Islam
- Tuhin HosenTHTuhin Hosen
- Rahat Bhuiyan1RBRahat Bhuiyan1
Open Access
- 21 December 2024
- conference paper
- Published by IEOM Society International
Abstract
This study focuses on optimizing input process parameters for the extrusion of alloyed steel (20MnCr5) using finite element simulation via DEFORM-3D software and the Taguchi method. The selection of appropriate process parameters is critical to minimize extrusion force, particularly when different material sets are involved. The research examines key parameters such as billet material properties, workpiece geometry, die angle, coefficient of friction, logarithmic strain, ram speed, and die length. Through DEFORM 3D simulation, the minimum extrusion force is predicted, and optimal process parameters are identified using Taguchi analysis. The regression analysis identified optimal conditions with a coefficient of friction at 0.08, die angle at 20°, and ram velocity at 1.5 mm/s, resulting in an extrusion force of 556291KN. ANOVA results indicate that die angle is the most influential factor, contributing 43.45% to the variation in extrusion force. Using an L27 (3^3) orthogonal array, the experiments were analyzed via MINITAB software. The analysis of extrusion speed's effect on temperature revealed a maximum die temperature of 600°C and billet temperature of 1030°C at ram speeds between 1-2 mm/s. Additionally, the temperature-stress relationship indicated the highest stress value of 1000 MPa at 20°C with 0.7% strain, while the lowest stress of 90 MPa occurred at 1050°C with 0% strain. The findings demonstrate the significant impact of optimized parameters on reducing extrusion force, enhancing process efficiency.Keywords
This publication has 17 references indexed in Scilit:
- Enhanced Ductility of a Fine‐Grained Mg–Gd–Al–Zn Magnesium Alloy by Hot ExtrusionAdvanced Engineering Materials, 2018
- Evaluation of microstructure and mechanical properties of aluminum AA7022 produced by friction stir extrusionJournal of Manufacturing Processes, 2018
- Interfacial structure and bonding mechanism of weld seams during porthole die extrusion of aluminum alloy profilesMaterials Characterization, 2018
- Upper bound analysis of differential velocity sideways extrusion process for curved profiles using a fan-shaped flow line modelInternational Journal of Lightweight Materials and Manufacture, 2018
- Finite Element Analysis and Experimental Study on Forward, Backward and Forward-backward Multi-hole Extrusion ProcessMaterials Today: Proceedings, 2018
- A study on the capability of equal channel forward extrusion processMaterials Science and Engineering: A, 2016
- Thermo‐mechanically coupled modeling and simulation of hot metal‐forming processes using adaptive remeshing methodGAMM-Mitteilungen, 2010
- Investigation of parameters affecting interface strength in Al/Cu clad bimetal rod extrusion processMaterials & Design (1980-2015), 2010
- Microstructure analysis of aluminum extrusion: Prediction of microstructure on AA6060 alloyJournal of Materials Processing Technology, 2008
- Experimental and numerical study of optimal die profile in cold forward rod extrusion of aluminumJournal of Materials Processing Technology, 2005