Mass Loss of Platinum-Rhodium Thermocouple Wires at 1324°C
Authors:
Open Access
- 1 October 2021
- journal article
- research article
- Published by Johnson Matthey Plc in Johnson Matthey Technology Review
- Vol. 65 (4) , 568-573
Abstract
It is known that platinum-rhodium thermocouples exhibit mass loss when in the presence of oxygen at high temperatures due to the formation of volatile oxides of platinum and rhodium. The mass losses of platinum, Pt-6%Rh and Pt-30%Rh wires, commonly used for thermocouples, were considered in this paper to characterise the mass loss of wires of the three compositions due to formation and evaporation of the oxides PtO2and RhO2under the conditions that would be seen by thermocouples used at high temperature. For the tests, the wires were placed in thin alumina tubes to emulate the thermocouple format, and the measurements were performed in air at a temperature of 1324°C, i.e. with oxygen partial pressure of 21.3 kPa. It was found that the mass loss of the three wires increases linearly with elapsed time, consistent with other investigations, up to an elapsed time of about 150 h, but after that, a marked acceleration of the mass loss is observed. Remarkably, previous high precision studies have shown that a crossover after about 150 h at 1324°C is also observed in the thermoelectric drift of a wide range of platinum-rhodium thermocouples, and the current results are compared with those studies. The mass loss was greatest for Pt-30%Rh, followed by Pt6%Rh, then platinum.Keywords
This publication has 12 references indexed in Scilit:
- A validated physical model of the thermoelectric drift of Pt-Rh thermocouples above 1200 °CMetrologia, 2020
- Stability assessment of a new high strength, high temperature Type R and Type S thermocoupleMeasurement Science and Technology, 2019
- Effect of Annealing on Drift in Type S Thermocouples Below $900\, ^{\circ }\hbox {C}$ 900 ∘ CInternational Journal of Thermophysics, 2015
- Thermoelectric homogeneity and stability of platinum-rhodium alloyed thermoelements of different compositionsAIP Conference Proceedings, 2013
- Annealing State Dependence of the Calibration of Type R and Type S ThermocouplesInternational Journal of Thermophysics, 2010
- Overcoming Inhomogeneity and Hysteresis Limitations of Type R Thermocouples in an International ComparisonInternational Journal of Thermophysics, 2007
- The effects of oxygen interaction with Pt-Rh catalytic alloysJournal of Materials Science, 1985
- Changes in seebeck coefficient of Pt and Pt 10% Rh after use to 1700 C in High-purity polycrystalline aluminaInternational Journal of Thermophysics, 1985
- High temperature behaviour of platinum group metals in oxidizing atmospheresJournal of the Less Common Metals, 1984
- The Oxidation of the Platinum MetalsPlatinum Metals Review, 1975