Optimal Lowest-Voltage-Switching for Boundary Mode Power Factor Correction Converters
Authors:
- 27 February 2014
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 30 (2) , 1042-1049
Abstract
This paper presents an optimal lowest-voltage-switching technique for boundary mode power factor correction (PFC) converters. The proposed approach minimizes the switching loss of the power MOSFET without additional discrete components. Optimal zero-voltage-switching or valley-switching can be achieved for universal input range. The gate driver delay can also be taken into account. A boundary mode boost PFC converter with the proposed optimal switching technique has been implemented using a 0.5-μm N-well process. Experimental results show that the proposed approach can realize optimal soft switching, and improve the efficiency of the boost PFC converter. The proposed lowest-voltage-switching technique can be applied to other resonant converters as well.Keywords
This publication has 17 references indexed in Scilit:
- Input Differential-Mode EMI of CRM Boost PFC ConverterIEEE Transactions on Power Electronics, 2013
- A ZVS Interleaved Boost AC/DC Converter Used in Plug-in Electric VehiclesIEEE Transactions on Power Electronics, 2012
- A Fully ZVS Critical Conduction Mode Boost PFCIEEE Transactions on Power Electronics, 2012
- A Novel DC-Side Zero-Voltage Switching (ZVS) Three-Phase Boost PWM Rectifier Controlled by an Improved SVM MethodIEEE Transactions on Power Electronics, 2012
- Soft-Switching Boost Converter With a Flyback Snubber for High Power ApplicationsIEEE Transactions on Power Electronics, 2011
- Active Power Factor Correction (PFC) Circuit With Resistor-Free Zero-Current DetectionIEEE Transactions on Power Electronics, 2010
- A new valley-detection method for the quasi-resonance switching2010
- Adaptive off-time control for variable-frequency, soft-switched flyback converter at light loadsIEEE Transactions on Power Electronics, 2002
- Single-stage single-switch input-current-shaping technique with reduced switching lossIEEE Transactions on Power Electronics, 2000
- The determination of the boundaries between continuous and discontinuous conduction modes in PWM DC-to-DC converters used as power factor preregulatorsIEEE Transactions on Power Electronics, 1995