Characterization of the mechanical and microstructural properties of cryogenic and austempering heat treatments on Mo alloyed ductile cast iron
Author:
Open Access
- 17 June 2026
- journal article
- Published by IOP Publishing in Materials Research Express
- Vol. 13 (12) , 126503
Abstract
This study examines the combined effects of molybdenum (Mo) alloying and deep cryogenic treatment (DCT) on the microstructure and mechanical response of austempered ductile iron (ADI). Ductile irons with three Mo contents (0.388, 0.671, and 0.990 wt.%) were produced, austempered at 400 °C, and subsequently subjected to DCT at −196 °C for 360 min. Microstructural and phase analyses were conducted using optical microscopy, scanning electron microscopy, high-resolution transmission electron microscopy, and x-ray diffraction (XRD). Austempering resulted in a typical ausferritic matrix, while the subsequent cryogenic step was associated with further microstructural refinement and features indicative of partial transformation of retained austenite. In addition, fine secondary features were observed locally and attributed to carbide-like precipitates. Quantitative XRD analysis revealed the presence of α and γ reflections in all heat-treated conditions. Detailed diffraction scans exhibited a distinct peak shift toward lower 2 θ angles following DCT, indicating an expansion of the lattice parameters and a corresponding enrichment of carbon within the austenite phase. In terms of mechanical response, the integration of austempering and DCT led to a 16.6% increase in hardness compared to the as-cast state. Furthermore, the combined heat treatment cycle resulted in a 42.3% enhancement in impact energy relative to the initial cast condition, highlighting the potential of DCT to optimize the structural integrity and toughness of Mo-alloyed ADI.Keywords
Funding Information
- Eskişehir Osmangazi Üniversitesi (FHD-2021-2189)
This publication has 36 references indexed in Scilit:
- Combined Effects of Molybdenum and Cooling Rate on Microstructure and Tribo-Mechanical Properties of Ductile IronInternational Journal of Metalcasting, 2025
- The Effect of Copper Content on the Microstructure and Mechanical Properties of Austempered, Cryogenically Treated Ductile Iron (ADI)International Journal of Metalcasting, 2025
- The Effect of Cryogenic Treatment on Hardness, Toughness, and Tribological Properties of Austempered Ductile Iron with Different Nickel ContentsInternational Journal of Metalcasting, 2021
- Influence of temperature and point defects on the X-ray diffraction pattern of graphiteCarbon Trends, 2021
- A review: phase transformation and wear mechanisms of single-step and dual-step austempered ductile ironsJournal of Materials Research and Technology, 2020
- Molybdenum alloying in cast iron and steelAdvances in Manufacturing, 2019
- Technical feasibility for use of FGD gypsum as an additive setting time retarder for Portland cementJournal of Materials Research and Technology, 2018
- Improvement in Abrasion Wear Resistance and Microstructural Changes with Deep Cryogenic Treatment of Austempered Ductile Cast Iron (ADI)Metallurgical and Materials Transactions A, 2016
- Austempered Materials for Powertrain ApplicationsJournal of Materials Engineering and Performance, 2013
- Enhancing the wear resistance of case carburized steel (En 353) by cryogenic treatmentCryogenics, 2005