Corrosion failure behaviours of PCBs in different marine atmospheric environments
Authors:
- 7 April 2026
- journal article
- research article
- Published by SAGE Publications in Corrosion Engineering, Science and Technology: The International Journal of Corrosion Processes and Corrosion Control
- Vol. 61 (8) , 1295-1308
Abstract
The corrosion failure behaviours of PCB-ImAg and PCB-ImSn were investigated after exposure in the atmospheric environments of Wanning and Yantai for 12 months under a shed. The results showed that after exposure in Wanning for 12 months, the change of PCB-ImAg impedance value was that the damaged Ag layer formed a galvanic system with the Cu substrate. Meanwhile, after exposure in Yantai, the change of PCB-ImSn impedance value was mainly due to the dissolution of the Sn layer accelerated by SO 2 . The corrosion products of printed circuit boards (PCBs) were basically the same in the atmospheric environments of Wanning and Yantai. However, the SO 2 content in the Yantai environment was higher than that in Wanning, and CuSO 4 ·3Cu(OH) 2 was detected in the corrosion products from Yantai. PCBs showed different degrees of electrochemical migration (ECM) in both atmospheric environments. The atmospheric environment of Wanning was more prone to the electrochemical migration of copper because the PCB surface was more likely to form a thin liquid film. In summary, it was confirmed that the corrosion failure behaviours of PCB-ImAg and PCB-ImSn had obvious environmental dependence on ECM behaviour, which was mainly related to the content of SO 2 in different atmospheric environments and the formation of a thin liquid film.Keywords
Funding Information
- Open Research Foundation of Southwest Technology and Engineering Research Institute (HDHDW59C020102)
- Science Fund of Shandong Laboratory of Advance Materials and Green Manufacturing at Yantai (AMGM2024F03)
- Taishan Scholar Foundation of Shandong Province (tsqn202306160)
This publication has 49 references indexed in Scilit:
- Dual‐Anion‐Stabilized Cuδ+ Sites in Cu2(OH)2CO3 for High C2+ Selectivity in the CO2 Electroreduction ReactionChemSusChem, 2024
- Early Corrosion Detection of Cu-Ag Wedge bonding in Semiconductor PackageJournal of Failure Analysis and Prevention, 2022
- Process and theoretical research on electroplating Cu–Sn alloys of low SnJournal of Applied Electrochemistry, 2021
- Artificial patina formation onto copper-based alloys: Chloride and sulphate induced corrosion processesApplied Surface Science, 2017
- Surface failure analysis of a field-exposed copper-clad plate in a marine environment with industrial pollutionApplied Surface Science, 2017
- Initial corrosion behavior of a copper-clad plate in typical outdoor atmospheric environmentsElectronic Materials Letters, 2016
- Initial Corrosion Behavior and Mechanism of PCB–HASL in Typical Outdoor Environments in ChinaJournal of Electronic Materials, 2015
- Electrochemical and XPS investigation of the corrosion behavior of Alloy 690 at high-temperature waterJournal of Solid State Electrochemistry, 2015
- Study of immersion silver and tin printed-circuit-board surface finishes in lead-free solder applicationsJournal of Electronic Materials, 2004
- Non‐destructive surface analysis applied to atmospheric corrosion of tinSurface and Interface Analysis, 2002