Failure analysis of tungsten based tool materials used in friction stir welding of high strength low alloy steels
Authors:
- S. Ragu NathanSNS. Ragu Nathan
- S. MalarvizhiSMS. Malarvizhi
- V. BalasubramanianVBV. Balasubramanian
- A.G. RaoARA.G. Rao
- 1 August 2016
- journal article
- Published by Elsevier in Engineering Failure Analysis
- Vol. 66, 88-98
Abstract
No abstract availableKeywords
Funding Information
- CARS (G8/15250/2011)
This publication has 16 references indexed in Scilit:
- Influences of tool shoulder diameter to plate thickness ratio (D/T) on stir zone formation and tensile properties of friction stir welded dissimilar joints of AA6061 aluminum–AZ31B magnesium alloysMaterials & Design (1980-2015), 2012
- An assessment of microstructure, hardness, tensile and impact strength of friction stir welded ferritic stainless steel jointsMaterials & Design (1980-2015), 2010
- Analysis of microstructural evolution during friction stir welding of ultrahigh-strength steelScripta Materialia, 2010
- Selection of FSW tool pin profile, shoulder diameter and material for joining AZ31B magnesium alloy – An experimental approachMaterials & Design (1980-2015), 2009
- Experimental and numerical investigation of the plunge stage in friction stir weldingJournal of Materials Processing Technology, 2008
- Analysis of first mode of metal transfer in friction stir welded plates by image processing techniqueJournal of Materials Processing Technology, 2008
- Tool materials selection for friction stir welding of L80 steelScience and Technology of Welding and Joining, 2007
- Dynamic and quasi-static torsional behavior of tungsten heavy alloy specimens fabricated through sintering, heat-treatment, swaging and agingMaterials Science and Engineering: A, 1998
- Deformation behavior and strengthening mechanisms at intermediate temperatures in W-La2O3Materials Science and Engineering: A, 1997
- Ballistic performance of high-strengh low-alloy steel weldmentsJournal of Materials Processing Technology, 1996