Effects of surface finishing procedures on the color, gloss, and surface roughness of CAD/CAM ceramics after coffee aging: an in vitro study surface finishing effects on CAD/CAM ceramics
Open Access
- 6 January 2026
- journal article
- Published by Anatolian Current Medical Journal in Anatolian Current Medical Journal
- Vol. 8 (1) , 159-166
Abstract
Aims: This in vitro study aimed to evaluate the effects of different surface finishing procedures-mechanical polishing, glazing, and polishing followed by glazing-on the color stability, surface roughness, and gloss of three CAD/CAM ceramic materials [feldspathic glass ceramic (GC), lithium disilicate (LDS), and zirconia-reinforced lithium silicate (ZLS)] after aging in a coffee solution. Methods: A total of 108 rectangular ceramic specimens (n=36 per material) were prepared in accordance with ISO 6872. Each material was divided into three subgroups based on the surface finishing procedure: mechanical polishing, glazing, and polishing+glazing. Baseline measurements of surface roughness (Ra), gloss (GU), and color (CIEDE2000, ΔE₀₀) were recorded. Specimens were aged in a coffee solution at 37 °C, and measurements were repeated at 1 week, 2 weeks, 1 month, and 2 months. At the end of the 2-month period, all specimens were re-polished and final measurements were obtained. Data were analyzed to determine material-, time-, and procedure-dependent differences. Results: Surface finishing protocols significantly affected all evaluated parameters (p < 0.05). Mechanical polishing produced the lowest Ra values (0.19±0.05 µm), while glazing alone resulted in the highest Ra after aging. The greatest increase in Ra was observed in zirconia-reinforced lithium silicate, whereas LDS maintained the lowest values throughout the study. The polishing+glazing protocol exhibited the highest GU (76.24±9.19 GU). LDS ceramic demonstrated the best GU retention, while ZLS showed the most pronounced loss over time. Both material type and finishing method significantly influenced ΔE₀₀ (pKeywords
This publication has 27 references indexed in Scilit:
- Alterations in color stability and anti-biofouling properties of various computer-aided design and computer-aided manufacturing glass–ceramics following ultraviolet weathering agingJournal of Dentistry, 2025
- Grasping the Lithium hype: Insights into modern dental Lithium Silicate glass-ceramicsDental Materials, 2022
- Different surface treatment strategies on etchable CAD-CAM materials: Part II—Effect on the bond strengthThe Journal of Prosthetic Dentistry, 2022
- Change in Color and Gloss Parameters of Stained Monolithic Resin-Ceramic CAD/CAM Materials After Simulated Aging: An In Vitro StudyThe International Journal of Prosthodontics, 2021
- Bioadhesion in the oral cavity and approaches for biofilm management by surface modificationsClinical Oral Investigations, 2020
- An in vitro evaluation of the effect of polishing on the stainability of different CAD/CAM ceramic materialsThe Saudi Dental Journal, 2020
- Materials in digital dentistry—A reviewJournal of Esthetic and Restorative Dentistry, 2020
- Color Stability of CAD/CAM Ceramics Prepared with Different Surface Finishing ProceduresJournal of Prosthodontics, 2019
- Color Difference Thresholds in DentistryJournal of Esthetic and Restorative Dentistry, 2015
- The influence of abutment surface roughness on plaque accumulation and peri‐implant mucositisClinical Oral Implants Research, 1996