Fast second harmonic injection characterization for efficiency enhancement of RF power amplifiers
- 1 November 2013
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
Abstract
A fast characterization method to determine the optimal second harmonic injection required at the input for enhancing the efficiency of RF power amplifiers is demonstrated. The second harmonic is injected with a small frequency offset to automatically sweep the phase during one modulation cycle. The power amplifier performance figures of merit are characterized over the second-harmonic amplitude and phase space. Time varying voltage and current waveforms are measured using a large signal network analyzer for a 15 W peak power packaged GaN device. The constructive second-harmonic injection exhibited improvements in efficiency of 11.7% and 30.5% compared, respectively, to the cases of (1) no injection with 50Ω termination and (2) destructive second-harmonic injection.Keywords
This publication has 12 references indexed in Scilit:
- Pulsed load-pull based optimal load-modulation PA design methodology for average efficiency enhancement2011
- Fast Multiharmonic Active Load–Pull System With Waveform Measurement CapabilitiesIEEE Transactions on Microwave Theory and Techniques, 2011
- Two-Stage GaN HEMT Amplifier With Gate–Source Voltage Shaping for Efficiency Versus Bandwidth EnhancementsIEEE Transactions on Microwave Theory and Techniques, 2010
- Experimental study on effect of second-harmonic injection at input of classes F and F −1 GaN power amplifiersElectronics Letters, 2010
- Practical waveform engineeringIEEE Microwave Magazine, 2009
- Pulsed Active Load–Pull Measurements for the Design of High-Efficiency Class-B RF Power Amplifiers With GaN HEMTsIEEE Transactions on Microwave Theory and Techniques, 2009
- New Ultra-fast Real-time Active Load-pull Measurements for High Speed RF Power Amplifier Design2007
- Broad-band poly-harmonic distortion (PHD) behavioral models from fast automated simulations and large-signal vectorial network measurementsIEEE Transactions on Microwave Theory and Techniques, 2005
- An Approach to Harmonic Load– and Source–Pull Measurements for High-Efficiency PA DesignIEEE Transactions on Microwave Theory and Techniques, 2004
- Class-E, Class-C, and Class-F power amplifiers based upon a finite number of harmonicsIEEE Transactions on Microwave Theory and Techniques, 2001