Generation of One-Dimensional Fibrous Polyethylene Nanocrystals in Epoxy Thermosets
Open Access
- 19 September 2022
- Vol. 14 (18) , 3921
Abstract
The one-dimensional (1D) polyethylene (PE) nanocrystals were generated in epoxy thermosets via crystallization-driven self-assembly. Toward this end, an ABA triblock copolymer composed of PE midblock and poly(ε-caprolactone) (PCL) endblocks was synthesized via the ring opening metathesis polymerization followed by hydrogenation approach. The nanostructured thermosets were obtained via a two-step curing approach, i.e., the samples were cured first at 80 °C and then at 150 °C. Under this condition, the one-dimensional (1D) fibrous PE microdomains with the lengths up to a couple of micrometers were created in epoxy thermosets. In contrast, only the spherical PE microdomains were generated while the thermosets were cured via a one-step curing at 150 °C. By the use of the triblock copolymer, the generation of 1D fibrous PE nanocrystals is attributable to crystallization-driven self-assembly mechanism whereas that of the spherical PE microdomains follows traditional self-assembly mechanism. Compared to the thermosets containing the spherical PE microdomains, the thermosets containing the 1D fibrous PE nanocrystals displayed quite different thermal and mechanical properties. More importantly, the nanostructured thermosets containing the 1D fibrous PE nanocrystals displayed the fracture toughness much higher than those only containing the spherical PE nanocrystals; the KIC value was even three times as that of control epoxy.Keywords
Funding Information
- National Natural Science Foundation of China (21774078, 51133003, 51973113)
This publication has 59 references indexed in Scilit:
- Exploring Microphase Separation Behavior of Epoxidized Poly(styrene-b-isoprene-b-styrene) Block Copolymer Inside Thin Epoxy CoatingsMacromolecules, 2013
- Synthesis of Sequence-Specific Vinyl Copolymers by Regioselective ROMP of Multiply Substituted CyclooctenesACS Macro Letters, 2012
- Nanostructured thermosets from self‐assembled amphiphilic block copolymer/epoxy resin mixtures: effect of copolymer content on nanostructuresPolymer International, 2009
- Strain rate effect on toughening of nano-sized PEP–PEO block copolymer modified epoxyActa Materialia, 2009
- Control of the block copolymer morphology in templated epoxy thermosetsJournal of Polymer Science Part B: Polymer Physics, 2007
- Block copolymer modified novolac epoxy resinJournal of Polymer Science Part B: Polymer Physics, 2003
- Nanostructures, Semicrytalline Morphology, and Nanoscale Confinement Effect on the Crystallization Kinetics in Self-Organized Block Copolymer/Thermoset BlendsMacromolecules, 2003
- Influence of Polymer Architecture on the Formation of Micelles of Miktoarm Star Copolymers Polyethylene/Poly(ethylenepropylene) in the Selective Solvent DecaneMacromolecules, 1997
- Rubber‐modified epoxies: III. Influence of the rubber molecular weight on the phase separation processPolymer International, 1994
- Rubber‐modified epoxies. II. Influence of the cure schedule and rubber concentration on the generated morphologyJournal of Applied Polymer Science, 1991