Influence of the Parallel C-Layer Secondary Air on Flow, Combustion and Nox Generation Characteristics of a 600mwe FW Down-Fired Boiler Retrofitted with a Stable Combustion Organization Mode
Authors:
- 5 September 2022
- journal article
- research article
- Published by Taylor & Francis in Combustion Science and Technology
- Vol. 196 (10) , 1529-1553
Abstract
To improve the low-load stable combustion capacity of a low-grade coal-fired boiler, this study proposed to reform C-layer secondary air, which was then used to improve the ignition and combustion stability of coal/airflow of a 600 MWe Foster Wheeler down-fired boiler. Cold airflow experiments and industrial measurements were carried out to investigate the influence of the new C-layer secondary air on the aerodynamic and combustion characteristics at low load under different C-layer secondary air ratios and damper openings, respectively. The flow and mixing characteristics of the C-layer secondary air and coal/airflow, the flue gas temperature and NOx, O2, and CO concentration distributions in the furnace at low load were examined. With increase in the C-layer secondary air ratio, the flow range of coal/airflow gradually expanded. The mixing distance first increased and then decreased. At an air ratio of 25%, the mixing distance was the longest. Industrial measurements showed that compared with that at the C-layer secondary air damper opening of 0%, the coal/airflow ignited earlier at 40% (corresponding to the C-layer secondary air ratio of 23.73%), and the flue gas temperature in the furnace increased substantially. At C-layer secondary air damper opening of 0%, 20%, and 40%, carbon content in the fly ash was 4.62%, 5.32%, and 4.20%, respectively. The respective NOx emissions at the furnace exits were 450 mg/Nm3, 378 mg/Nm3, and 427 mg/Nm3, (O2 = 6%). In actual operation, 40% is recommended as the optimal C-layer secondary air damper opening.Keywords
Funding Information
- Heilongjiang Touyan Innovation Team Program
This publication has 28 references indexed in Scilit:
- Overall review of peak shaving for coal-fired power units in ChinaRenewable and Sustainable Energy Reviews, 2016
- A novel coal combustion technology for a down-fired boiler: Aerodynamic characteristicsFuel Processing Technology, 2014
- Cold-modeling flow characteristics for a 300-MWe down-fired furnace at different secondary-air distributionsInternational Journal of Thermal Sciences, 2013
- Arch- and wall-air distribution optimization for a down-fired 350 MWe utility boiler: A cold-modeling experimental study accompanied by real-furnace measurementsApplied Thermal Engineering, 2013
- Principles of optimization of combustion by radiant energy signal and its application in a 660 MWe down- and coal-fired boilerKorean Journal of Chemical Engineering, 2011
- Combustion and NO emission characteristics of a retrofitted down-fired 660 MWe utility boiler at different loadsApplied Energy, 2011
- Bituminous coal combustion in a full-scale start-up ignition burner: Influence of the excess air ratioEnergy, 2010
- Influence of coal-feed rates on bituminous coal ignition in a full-scale tiny-oil ignition burnerFuel, 2009
- Influence of oil‐atomized air on flow and combustion characteristics in a 300 MWe down‐fired boilerAsia-Pacific Journal of Chemical Engineering, 2009
- Reducing the minimum load and NOx emissions for lignite-fired boiler by applying a stable-flame conceptApplied Energy, 2003