Different Underlying Corrosion Mechanism for Mg Bulk Alloys and Mg Thin Films
Open Access
- 6 May 2009
- journal article
- pse proceedings---full-paper
- Published by Wiley in Plasma Processes and Polymers
- Vol. 6 (S1) , S690-S694
Abstract
The influence of microstructure on the corrosion resistance of magnesium alloys was studied by comparing standard cast alloys with thin‐film alloys (solid solution) of the same nominal composition. Latter were deposited on Si by means of magnetron sputtering. Results from potentiodynamic polarisation measurements, electrochemical impedance spectroscopy (EIS) and immersion tests with inductively coupled plasma (ICP) spectroscopy of the aqueous NaCl solution prove that beside lower corrosion rates for the thin films, a different corrosion mechanism is active in both systems, due to the dissimilar microstructure. Localised or pitting corrosion is dominating for the bulk alloys and uniform corrosion (on a much lower level) for the coatings.Keywords
This publication has 7 references indexed in Scilit:
- Deposition and properties of novel microcrystalline Mg alloy coatingsSurface Engineering, 2007
- Structure and Corrosion of Magnetron Sputtered Pure Mg Films on Silicon SubstratesPlasma Processes and Polymers, 2007
- Corrosion Properties of Supersaturated Magnesium Alloy SystemsMaterials Science Forum, 2007
- Influence of ion energy on properties of Mg alloy thin films formed by ion beam sputter depositionSurface and Coatings Technology, 2006
- Characterisation of corrosion products formed on PVD in situ mechanically worked Mg–Ti alloysJournal of Alloys and Compounds, 2005
- Cold Coating of Magnesium Base Alloy Films by Ion Beam SputteringMaterials Science Forum, 2003
- MagnesiumMaterials Science and Engineering: A, 2001