Measurement and analysis of winding stresses in dry-wound pancake coils considering nonlinear compressive behaviors
- 27 September 2023
- journal article
- research article
- Published by IOP Publishing in Superconductor Science and Technology
- Vol. 36 (11) , 115019
Abstract
Considering coil stress management, conductor thermal stability, and susceptibility to delamination, the dry-winding approach has been gradually applied and tested in high-temperature-superconducting coils wound with REBa2Cu3O 7 − x (REBCO) coated conductors (CCs). In dry-wound coils, the winding tension can be a useful tool for managing the mechanical stresses and maintaining the structural stability. It is also related to the contact resistivity characteristics of no-insulation and metal-as-insulation coils. In this paper, we present a study on the winding stresses in dry-wound pancake coils considering nonlinear compressive behaviors in the radial direction. Coils wound with stainless-steel (SS) tapes and REBCO CCs were prepared, respectively, with various sizes (90–140 turns) and winding tensions (26–61 MPa). The radial pressure was obtained by applying the pressure measurement films, which cover a pressure range up to 50 MPa. A relatively moderate radial pressure buildup was observed in coils wound with SS tapes, indicating that the effective radial modulus of the coil as an entity is considerably lower compared to the tensile modulus in the azimuthal direction. This is consistent with the nonlinear stress–strain relationship of stacked thin sheets under transverse compression, which can be further explained by the contact behaviors between two rough surfaces. The average radial pressure in CC coils shared similar characteristics as that in SS coils, whereas the radial stress along the conductor edges were significantly higher compared to the middle. Cross-sectional microscopy of the CCs suggests that this can be primarily attributed to the thickness variations across the conductor width. These results suggest that the microscopic rough-surface contact and thickness variation of the wound tape play a critical role in the coil stiffness as well as the winding stress distributions.Keywords
Funding Information
- Seoul National University (BK21 FOUR program of the Education and Research Program for Future ICT Pioneers)
- Applied Superconductivity Center, Electric Power Research Institute of Seoul National University
- National Research Foundation of Korea (2022M3I9A1073924)
This publication has 41 references indexed in Scilit:
- Characterization of transverse tensile stress response of critical current and delamination behaviour in GdBCO coated conductor tapes by anvil testSuperconductor Science and Technology, 2013
- Analysis of Large Deformation Wound Roll ModelsJournal of Applied Mechanics, 2013
- Delamination strength of YBCO coated conductors under transverse tensile stressSuperconductor Science and Technology, 2007
- A Hybrid Approach for Quantifying the Winding Process and Material Effects on Sheet Coil DeformationJournal of Engineering Materials and Technology, 2004
- Macroscopic Effects of Surface Roughness in Confined Air FlowJournal of Fluids Engineering, 2004
- Stress Field in Finite Width Axisymmetric Wound RollsJournal of Applied Mechanics, 2001
- Generalized plane strain analysis of superconducting solenoidsJournal of Applied Physics, 1999
- Stresses in superconducting solenoidsJournal of Applied Physics, 1977
- The Contact of Two Nominally Flat Rough SurfacesProceedings of the Institution of Mechanical Engineers, 1970
- Contact of nominally flat surfacesProceedings of the Royal Society of London. A. Mathematical and Physical Sciences, 1966