Influence of Stitch Angle on the Flexural Response of Composite Structures
- 1 September 2024
- journal article
- research article
- Published by American Institute of Aeronautics and Astronautics (AIAA) in Journal of Aircraft
- Vol. 61 (5) , 1475-1481
Abstract
Utilizing lightweight composites in aerospace vehicles plays a pivotal role in sustainability by improving fuel efficiency and mitigating emissions. However, due to their low interlaminar strength, delaminations and microcracking degrade their strength and stiffness properties. Through-thickness stitching improves the interlaminar strength, thus increasing the delamination tolerance of composite structures. Therefore, in this study, the influence of repeated periodic stitching patterns, stitched at three different angles (0, 45, and 90°) w.r.t. the transverse direction, on the flexural properties of stitched composites is investigated. The strain distributions of these specimens were obtained using a single continuous optical fiber bonded to the tensile surface of the specimens. The results show that stitching at a 45° angle produced lower strains and higher flexural strength and bending modulus when compared to the stitched and unstitched laminates. An increase of 32.3 and 47.4% in the flexural strength and bending modulus were obtained, respectively, with reference to the unstitched laminates. The failure morphology of specimens was also analyzed using optical microscopy and revealed that the stitch seams arrested delaminations. However, due to the 45° angle, the damage progressed along a longer distance, thus resulting in an increased ultimate failure load.Keywords
This publication has 35 references indexed in Scilit:
- Flexural Behaviour of Unreinforced and Z-Fibre Reinforced 3D Carbon/Epoxy CompositesApplied Composite Materials, 2021
- Improvement of Mode I Interlaminar Fracture Toughness of Stitched Glass/Epoxy CompositesApplied Composite Materials, 2016
- Damage characteristics in 3D stitched composites with various stitch parameters under in-plane tensionComposites Part A: Applied Science and Manufacturing, 2015
- A mechanistic interpretation of the comparative in-plane mechanical properties of 3D woven, stitched and pinned compositesComposites Part A: Applied Science and Manufacturing, 2010
- Stitched glass/PP composite. Part I: Tensile and impact propertiesComposites Part A: Applied Science and Manufacturing, 2009
- Review of z-pinned composite laminatesComposites Part A: Applied Science and Manufacturing, 2007
- Estimating deflection of a simple beam model using fiber optic bragg-grating sensorsExperimental Mechanics, 2004
- Flexural properties of stitched GRP laminatesComposites Part A: Applied Science and Manufacturing, 1996
- Improving the delamination resistance of CFRP by stitching—a reviewComposites Science and Technology, 1994
- Fracture behavior in stitched multidirectional compositesMaterials Science and Engineering: A, 1989