Implementation of AASHTOWare Pavement ME Design Software for Asphalt Pavements in Kansas
Authors:
- 19 March 2019
- journal article
- research article
- Published by SAGE Publications in Transportation Research Record: Journal of the Transportation Research Board
- Vol. 2673 (4) , 490-499
Abstract
Many highway agencies are transitioning from the 1993 AASHTO pavement design guide to the AASHTOWare Pavement ME Design (PMED). Pavement performance models embedded in the PMED software need to be calibrated for new and reconstructed hot-mix asphalt (HMA) pavements. Twenty-seven newly constructed HMA pavements were used to calibrate the prediction models—twenty-one for calibration and six for validation. Local calibration for permanent deformation, top-down fatigue cracking, and the International Roughness Index (IRI) models was done using the traditional split-sample method. Comparison with the results from the 1993 AASHTO design guide for ten new HMA pavement sections with varying traffic levels was done. The results show that the thicknesses obtained from locally calibrated PMED are within 1 inch of the AASHTO 1993 design guide prediction for low to medium-low traffic. For sections with high traffic level, the 1993 AASHTO design guide yielded higher thickness than PMED. The PMED implementation strategies adopted in Kansas and relevant concerns are discussed. Finally, an automated calibration technique has been proposed to help highway agencies to perform periodic in-house calibration of the performance models.Keywords
This publication has 5 references indexed in Scilit:
- Implementation of the AASHTO Mechanistic-Empirical Pavement Design Guide and Software2014
- Comparisons of Flexible Pavement Designs: AASHTO Empirical Versus NCHRP Project 1-37A Mechanistic-EmpiricalTransportation Research Record: Journal of the Transportation Research Board, 2006
- Implementation Initiatives of the Mechanistic-Empirical Pavement Design Guides in IndianaTransportation Research Record: Journal of the Transportation Research Board, 2005
- Multi-objective global optimization for hydrologic modelsJournal of Hydrology, 1998
- Optimization Methods Applied to Selecting Support Positions in Fixture DesignJournal of Engineering for Industry, 1991