Study on the warm air bending of NM400TP wear-resistant steel sheets heated by online floating contact heating module
Authors:
- 25 June 2025
- journal article
- Published by IOP Publishing in Modelling and Simulation in Materials Science and Engineering
- Vol. 33 (5) , 055016
Abstract
To address the challenge posed by the reduced cold formability of high-strength steel sheets in industrial applications, a novel warm air bending method utilizing an online local contact heating module was investigated. NM400TP high strength low alloy wear-resistant steel sheets were used in experiment and numerical simulation to verify the bending process. A thermo-mechanical coupled model, taking into account the material heterogeneity, was constructed to predict the bending outcomes under various conditions of temperatures and forming speeds. The results proved the validation of the new method in improving the bendability of NM400TP plates, and the model can reveal the heat transfer processes, heterogeneous deformation and fracture characteristics during warm air bending. In comparison to conventional cold air bending, warm air bending conditions with a stamping speed of 1000 mm min−1 and a temperature of 350 °C promoted 54% increase in the bending limit angle and a remarkable reduction in the forming load.Keywords
Funding Information
- Key Technology Project of HBIS Group (HG2024128)
This publication has 37 references indexed in Scilit:
- Quasi-brittle Deformation and Fracture Behaviors of NM450TP High-Strength Wear-Resistant Steel Plates during Twice Tensile TestJournal of Materials Engineering and Performance, 2022
- Modeling and simulation of hot stamping process for medium manganese steel alloyInternational Journal of Material Forming, 2022
- The Effect of the tooling temperature on the mechanical properties of CSC-15B22 Steel sheets that undergo tailored temperingInternational Journal of Material Forming, 2021
- Prediction of forming limits and microstructural evolution during warm stretch forming of DP590 steelArchives of Civil and Mechanical Engineering, 2021
- Advanced FE model validation of cold-forming process using DIC: Air bending of high strength steelInternational Journal of Material Forming, 2020
- The Influence of Microstructure on the Bendability of Direct Quenched Wear Resistant SteelSteel Research International, 2019
- Experimental investigation of non-isothermal deep drawing of DP600 steelThe International Journal of Advanced Manufacturing Technology, 2018
- Study on springback from thermal-mechanical boundary condition imposed to V-bending and L-bending processes coupled with infrared rays local heatingInternational Journal of Material Forming, 2017
- Experimental research on warm deep drawing of HC420LA grade sheet materialThe International Journal of Advanced Manufacturing Technology, 2016
- Thermo-mechanical coupled 3D-FE modeling of heat rotary draw bending for large-diameter thin-walled CP-Ti tubeThe International Journal of Advanced Manufacturing Technology, 2014