Underwater Laser Turning of Commercially-Pure Titanium
- 2 September 2020
- journal article
- research article
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 861, 23-27
Abstract
Underwater laser machining process is a material removal technique that can minimize thermal damage and offer a higher machining rate than the laser ablation in ambient air. This study applied the underwater method associated with a nanosecond pulse laser for turning a commercially pure titanium rod. The effects of laser power, surface speed and number of laser passes on machined depth and surface roughness were investigated in this work. The results revealed that a deeper cut depth and smoother machined surface than those obtained from the laser ablation in ambient air were achievable when the underwater laser turning process was applied. The machined depth and surface roughness were found to significantly increase with the laser power and number of laser passes. The findings of this study can disclose the insight as well as potential of the underwater laser turning process for titanium and other similar metals.Keywords
This publication has 10 references indexed in Scilit:
- Pulsed Nd:YAG Laser Micro-turning of Alumina to Study the Effect of Overlap Factors on Surface Roughness PerformanceIOP Conference Series: Materials Science and Engineering, 2018
- Dynamic features of bubble induced by a nanosecond pulse laser in still and flowing waterOptics & Laser Technology, 2018
- Underwater Laser Micromilling of Commercially-Pure Titanium Using Different Scan OverlapsIOP Conference Series: Materials Science and Engineering, 2018
- Cavity formation and surface modeling of laser milling process under a thin-flowing water layerApplied Surface Science, 2016
- Laser micro-milling under a thin and flowing water layer: A new concept of liquid-assisted laser machining processProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2015
- Laser ablation of silicon in water under different flow ratesThe International Journal of Advanced Manufacturing Technology, 2014
- Optimization of near-infrared laser drilling of silicon carbide under waterInternational Journal of Heat and Mass Transfer, 2014
- A Comparison of Dry and Underwater Laser Micromachining of Silicon SubstratesKey Engineering Materials, 2010
- Experimental analysis on Nd:YAG laser micro-turning of alumina ceramicThe International Journal of Advanced Manufacturing Technology, 2010
- Pulsed Nd:YAG laser turning of micro-groove on aluminum oxide ceramic (Al2O3)International Journal of Machine Tools and Manufacture, 2008