Three-Coil Wireless Charging System for Metal-Cover Smartphone Applications
- 1 October 2019
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 35 (5) , 4847-4858
Abstract
A three-coil wireless charging system is proposed for full metal-cover smartphone applications. Considering the space limitation and other antennas in the smartphone, the receiver coil embedded in the smartphone is designed to be miniaturized as 16 mm × 65 mm. By integrating a series capacitance at the end of the 2 mm width narrow horizontal slot loading on the metal cover, the metal cover is converted to a relay coil of the three-coil system and wireless power transfer through the metal cover is thus achieved. A prototype of the proposed three-coil system has been built and wireless power transfer through metal cover has been validated via experiment. The experimental results show that the prototype achieves 5 W output power with 71% coil-to-coil efficiency.Keywords
Funding Information
- National Natural Science Foundation of China (61471098)
- National Higher-Education Institution General Research and Development Project (ZYGX2016J035, ZYGX2018J037)
- China Scholarship Council
This publication has 19 references indexed in Scilit:
- Wireless Power Transfer to Multiple Loads Over Various Distances Using Relay ResonatorsIEEE Microwave and Wireless Components Letters, 2015
- A Methodology for Making a Three-Coil Wireless Power Transfer System More Energy Efficient Than a Two-Coil Counterpart for Extended Transfer DistanceIEEE Transactions on Power Electronics, 2015
- An Inductive Power Transfer through metal object2013
- Inductive Power TransferProceedings of the IEEE, 2013
- General Analysis on the Use of Tesla's Resonators in Domino Forms for Wireless Power TransferIEEE Transactions on Industrial Electronics, 2011
- Investigation of Methods for Data Communication and Power Delivery Through MetalsIEEE Transactions on Industrial Electronics, 2011
- Magnetic Resonant Coupling As a Potential Means for Wireless Power Transfer to Multiple Small ReceiversIEEE Transactions on Power Electronics, 2009
- Design and Test of a High-Power High-Efficiency Loosely Coupled Planar Wireless Power Transfer SystemIEEE Transactions on Industrial Electronics, 2008
- Design and Implementation of Low-Profile Contactless Battery Charger Using Planar Printed Circuit Board Windings as Energy Transfer DeviceIEEE Transactions on Industrial Electronics, 2004
- Evaluation of the shielding effects on printed-circuit-board transformers using ferrite plates and copper sheetsIEEE Transactions on Power Electronics, 2002