Radiated EMI Estimation From DC–DC Converters With Attached Cables Based on Terminal Equivalent Circuit Modeling
- 22 December 2017
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electromagnetic Compatibility
- Vol. 60 (6) , 1769-1776
Abstract
An equivalent two terminal model based on the Thevenin equivalents describes the common mode (CM) currents on the input and output side of two widely used types of dc-to-dc power converters—buck and boost. Thus, it describes a nonlinear circuit by a linear equivalent circuit. The maximized spectrum of the CM currents is extracted for converters with stochastic signals using a novel characterization procedure. The extracted Thevenin model is used in co-simulation combined with a full-wave electromagnetic solver to predict the radiated emissions from the system consisting of the shielded dc–dc converters with attached cables and a DC brushless motor as load. The results using the terminal model agree well with the measurements providing that the actual CM loads are within the range of CM loads used while obtaining the Thevenin equivalent circuit.Keywords
Funding Information
- National Science Foundation (1440110)
This publication has 15 references indexed in Scilit:
- Common mode current prediction from a power converter with attached cables based on a terminal equivalent circuit model2016
- Terminal model application for characterizing conducted EMI in boost converter system2016
- Modeling EMI Due to Display Signals in a TVIEEE Transactions on Electromagnetic Compatibility, 2015
- A Measurement-Based Model of the Electromagnetic Emissions From a Power InverterIEEE Transactions on Power Electronics, 2014
- Determining Far-Field EMI From Near-Field Coupling of a Power ConverterIEEE Transactions on Power Electronics, 2014
- EMI Behavioral Models of DC-Fed Three-Phase Motor Drive SystemsIEEE Transactions on Power Electronics, 2014
- A Simple Method of Estimating the Radiated Emission From a Cable Attached to a Mobile DeviceIEEE Transactions on Electromagnetic Compatibility, 2012
- Analysis of EMI Terminal Modeling of Switched Power ConvertersIEEE Transactions on Power Electronics, 2012
- Effects of Parasitic Parameters on EMI Filter PerformanceIEEE Transactions on Power Electronics, 2004
- Analysis of conducted EMI emissions from PWM inverter based on empirical models and comparative experiments2003