Field trials of a methodology for locomotive brake testing to assess friction enhancement in the wheel/rail interface using a representative leaf layer
Open Access
- 16 November 2020
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part F: Journal of Rail and Rapid Transit
- Vol. 235 (9) , 1053-1064
Abstract
There are two options for testing the performance of rail vehicles and the application of material to the wheel/rail interface to influence friction, and therefore braking performance, in a low adhesion environment: laboratory work which is not representative of conditions in the field, and expensive track tests using fully instrumented modern vehicles largely using low adhesion simulants that are not representative of those that occur in the real world and usually applied over great lengths of track. This paper presents a third option: low-cost track tests. We determined the minimum of equipment and resources needed to produce low adhesion using a method more representative on Autumn conditions on rail and monitor the performance of rail vehicles when braking on it. This was mainly targeted at use for testing products applied to the wheel/rail interface to enhance traction, hence the need for real low adhesion causes. We present the methodology that we have developed, and some initial results showing that using it we can generate a low adhesion scenario when braking from 10 mph. This can be used to develop mitigation solutions for low adhesion in a more cost effective manner.Keywords
Funding Information
- Rail safety standards board (SC04-POB-15)
This publication has 20 references indexed in Scilit:
- Effect of the presence of moisture at the wheel–rail interface during dew and damp conditionsProceedings of the Institution of Mechanical Engineers, Part F: Journal of Rail and Rapid Transit, 2017
- Field measurement of coefficient of friction in rails using a hand-pushed tribometerTribology International, 2015
- Transient wheel–rail adhesion characteristics under the cleaning effect of slidingVehicle System Dynamics, 2014
- Influence of partial slip and direction of traction on wear rate in wheel-rail contactWear, 2011
- Laboratory investigation of some sanding parameters to improve the adhesion in leaf-contaminated wheel—rail contactsProceedings of the Institution of Mechanical Engineers, Part F: Journal of Rail and Rapid Transit, 2010
- The development of a low creep regime, hand-operated tribometerWear, 2008
- Twin disc assessment of wheel/rail adhesionWear, 2008
- The effects of top of rail friction modifier on wear and rolling contact fatigue: Full-scale rail–wheel test rig evaluation, analysis and modellingWear, 2008
- Temperature in a twin-disc wheel/rail contact simulationTribology International, 2006
- Comparison of the wear process for eutectoid rail steels: Field and laboratory testsWear, 1987