Optical monitoring of polypropylene crystallization during injection molding
Open Access
- 26 December 2007
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 48 (2) , 257-266
Abstract
The nonisothermal crystallization of polypropylene resins, i‐PP, during injection molding, using an optical device inserted in the injection mold cavity was monitored. The device detected the change of optical properties which occurs in polymers during their crystallization process; thus the intensity of a laser beam after it passed through the crystallizing polymer was measured during an injection molding cycle. The collected light intensity after the end of the cycle was correlated with the morphologies and final crystallinity degree of the samples. The influence of nucleating agents and the change of the parameters of the injection molding process on the morphology and optical signals were also investigated. The morphologies were analyzed by polarized light optical microscopy, PLOM. The % of crystallinity of the samples was measured by wide angle X‐rays diffraction, WAXS. It was concluded that the optical device was sensible to different polymer crystallization kinetics, morphology type, and changes in the injection molding parameters. It was also found that the mold temperature and packing pressure and time were the factors that affected most the kinetics of crystallization of these polymers in this particular disk geometry. The WAXS results showed that the lower the final light intensity the higher the % of crystallinity in the samples. POLYM. ENG. SCI., 2008. © 2007 Society of Plastics EngineersKeywords
This publication has 20 references indexed in Scilit:
- Injection-moulded α- and β-polypropylenes: I. Structure vs. processing parametersEuropean Polymer Journal, 2005
- Morphological distribution of injection-moulded isotactic polypropylene: a study of synchrotron small angle X-ray scatteringPolymer, 2004
- Development of the skin layer in injection moulding: phenomenological modelPolymer, 2004
- Characterization of i‐PP shear‐induced crystallization layers developed in a slit dieJournal of Applied Polymer Science, 2004
- The effect of nucleating agent on the crystalline morphology of polypropylene (PP)Materials & Design (1980-2015), 2003
- The research on aggregation structure of PP materials under different condition and the influence on mechanical propertiesMaterials & Design (1980-2015), 2002
- Comparison of structure development in injection molding of isotactic and syndiotactic polypropylenesPolymer Engineering & Science, 2002
- The thermomechanical environment and the microstructure of an injection moulded polypropylene copolymerPolymer, 2002
- Crystallinity and microstructure in injection moldings of isotactic polypropylenes. Part 1: A new approach to modeling and model parametersPolymer Engineering & Science, 1999
- Effect of interference between anisotropic scattering entities on light scattering from polymer films. II. The correlation function approachJournal of Polymer Science: Polymer Physics Edition, 1974