Zinc oxide pieces obtained by pressing and slip casting: physical, structural and photocatalytic properties
- 7 November 2019
- journal article
- research article
- Published by Taylor & Francis in Environmental Technology
- Vol. 42 (12) , 1861-1873
Abstract
Photocatalysis is a promising alternative for the decontamination of effluents. In this paper, immobilized ZnO-based photocatalysts were obtained by pressing and by slip casting. The cylindrical pieces were heat treated at 800°C. The samples were characterized by the method based on the principle of Archimedes, XRD, FTIR, Raman, diffuse reflectance and SEM. The samples obtained by slip casting presented lower apparent density (3.12 ± 0.04 g/cm3), higher apparent porosity (44.87 ± 0.47%) and smaller grain size (0.48 ± 0.05 µm) when compared to the pressed samples, with mean apparent density of 5.37 ± 0.08 g/cm3, apparent porosity of 1.56 ± 0.10% and grain size of 0.64 ± 0.02 µm. The performances of the samples were attested by the photocatalytic degradation of Rhodamine B (RhB) under UV-C irradiation (maximum intensity at 254 nm). The samples obtained by slip casting showed photocatalytic degradation between 80 and 90%, while the pressed samples showed degradation between 40 and 60%. The reuse of the photocatalysts was evaluated over five cycles of photocatalytic degradation, in which there was no loss of performance of the samples obtained by slip casting; however, the pressed samples showed a loss of photocatalytic efficiency starting from the third cycle. Photocatalytic assays were carried out with different dye concentrations, in which the slip casting samples showed better photocatalytic efficiency (degradation of 80% for a RhB concentration of 10 mg/L) due to higher porosity and surface area compared to pressed samples, and there was a loss of performance in higher concentrations.Keywords
Funding Information
- CAPES (APQ-01898-13)
- CNPq (444117/2014-8)
- Embrapa (SEG 01.14.03.001.01.00)
- Fundação de Amparo à Pesquisa do Estado de Minas Gerais (APQ-01898-13)
This publication has 36 references indexed in Scilit:
- Effective photocatalytic degradation of rhodamine B dye by ZnO nanoparticlesMaterials Letters, 2013
- Efficient decolorization of azo dye solution by visible light-induced photocatalytic process using SnO2/ZnO heterojunction immobilized in chitosan matrixChemical Engineering Journal, 2011
- A surface science perspective on TiO2 photocatalysisSurface Science Reports, 2011
- Influence of TiO2 morphological parameters in dye photodegradation: A comparative study in peroxo-based synthesisApplied Catalysis B: Environment and Energy, 2011
- Synthesis and photocatalysis properties of ZnO structures with different morphologies via hydrothermal methodApplied Surface Science, 2011
- Immobilisation of titanium dioxide onto supporting materials in heterogeneous photocatalysis: A reviewApplied Catalysis A: General, 2010
- ZnO Nanoparticles Immobilized on Flaky Layered Double Hydroxides as Photocatalysts with Enhanced Adsorptivity for Removal of Acid Red GLangmuir, 2010
- Heterogeneous photocatalytic degradation of reactive dyes in aqueous TiO2 suspensions: Decolorization kineticsChemical Engineering Journal, 2009
- Photocatalytic degradation of C.I. Acid Red 27 by immobilized ZnO on glass plates in continuous-modeJournal of Hazardous Materials, 2007
- Photocatalytic properties of titania powders prepared by hydrothermal methodApplied Catalysis B: Environment and Energy, 2004