Design and Fabrication of a MEMS Electromagnetic Swing-Type Actuator for Optical Switch
Open Access
- 22 February 2021
- journal article
- research article
- Published by MDPI AG in Micromachines
- Vol. 12 (2) , 221
Abstract
A microelectromechanical systems system (MEMS) electromagnetic swing-type actuator is proposed for an optical fiber switch in this paper. The actuator has a compact size of 5.1 × 5.1 × 5.3 mm3, consisting of two stators, a swing disc (rotator), a rotating shaft, and protective covers. Multi-winding stators and a multipole rotator were adopted to increase the output torque of the actuator. The actuator’s working principle and magnetic circuit were analyzed. The calculation results show that the actuator’s output torque is decisive to the air gap’s magnetic flux density between the stators and the swing disc. NiFe alloy magnetic cores were embedded into each winding center to increase the magnetic flux density. A special manufacturing process was developed for fabricating the stator windings on the ferrite substrate. Six copper windings and NiFe magnetic cores were electroplated onto the ferrite substrates. The corresponding six magnetic poles were configured to the SmCo permanent magnet on the swing disc. A magnetizing device with a particular size was designed and fabricated to magnetize the permanent magnet of the swing disc. The actuator prototype was fabricated, and the performance was tested. The results show that the actuator has a large output torque (40 μNm), fast response (5 ms), and a large swing angle (22°).Keywords
Funding Information
- Natural Science Foundation of Jiangxi Province (20202BAB204019)
- National Natural Science Foundation of China (52075429 and 92060110)
This publication has 22 references indexed in Scilit:
- A high-sensitivity optical fiber relative humidity sensor based on microsphere WGM resonatorOptical Fiber Technology, 2018
- Review of optical fibers-introduction and applications in fiber lasersResults in Physics, 2018
- A Review of Distributed Optical Fiber Sensors for Civil Engineering ApplicationsSensors, 2016
- Devices Based on Co-Integrated MEMS Actuators and Optical Waveguide: A ReviewMicromachines, 2016
- Large size MEMS scanning mirror with vertical comb drive for tunable optical filterOptics and Lasers in Engineering, 2013
- Optical switching: switch fabrics, techniques, and architecturesJournal of Lightwave Technology, 2003
- Finite element simulation and theoretical analysis of fiber-optical switchesSensors and Actuators A: Physical, 2002
- Free-space fiber-optic switches based on MEMS vertical torsion mirrorsJournal of Lightwave Technology, 1999
- Application of MEMS technology in automotive sensors and actuatorsProceedings of the IEEE, 1998
- MEMS milliactuator for hard-disk-drive tracking servoJournal of Microelectromechanical Systems, 1998