Bilevel vs. Passive Equalizers for Second Life EV Batteries
Open Access
- 7 February 2021
- journal article
- research article
- Published by MDPI AG in Electricity
- Vol. 2 (1) , 63-76
Abstract
Once lithium-ion batteries degrade to below about 80% of their original capacity, they are no longer considered satisfactory for electric vehicles (EVs), but they are still adequate for second-life energy storage applications. However, once this level is reached, capacity fade increases at a much faster rate, and the spread between the cell capacities becomes much wider. If the passive equalizer (PEQ) from the EV is still used, battery capacity remains equal to that of the worst cell in the stack, just like it was in the EV. Unfortunately, the worst cell eventually becomes much weaker than the cell average, and the other cells are not fully utilized. If operated while the battery is in use, an active equalizer (AEQ) can increase the battery capacity to a much higher value close to the cell average, but AEQs are much more expensive and are not considered cost effective. However, it can be shown that the bilevel equalizer (BEQ), a PEQ/AEQ hybrid, also can provide a capacity very close to the cell average and at a much lower cost than an AEQ.Keywords
Funding Information
- University of Toledo (R-1258/17-02-W16)
This publication has 26 references indexed in Scilit:
- Technoeconomic model of second-life batteries for utility-scale solar considering calendar and cycle agingApplied Energy, 2020
- Lifetime Test Design for Second-Use Electric Vehicle Batteries in Residential ApplicationsIEEE Transactions on Sustainable Energy, 2017
- Failure statistics for commercial lithium ion batteries: A study of 24 pouch cellsJournal of Power Sources, 2017
- Quantifying Uncertainties in Reusing Lithium-Ion Batteries from Electric VehiclesProcedia Manufacturing, 2017
- Lithium-ion cell-to-cell variation during battery electric vehicle operationJournal of Power Sources, 2015
- Production caused variation in capacity aging trend and correlation to initial cell performanceJournal of Power Sources, 2014
- Analysis of ageing inhomogeneities in lithium-ion battery systemsJournal of Power Sources, 2013
- Evaluation of commercial lithium-ion cells based on composite positive electrode for plug-in hybrid electric vehicle applications. Part II. Degradation mechanism under 2C cycle agingJournal of Power Sources, 2011
- Fast equalization for large lithium ion batteriesIEEE Aerospace and Electronic Systems Magazine, 2009
- Design considerations for charge equalization of an electric vehicle battery systemIEEE Transactions on Industry Applications, 1999