Ngalula Sandrine Mubenga
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Ngalula Sandrine Mubenga has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Thomas Stuart
Electrical Engineering and Computer Science Department, University of Toledo, 2801 W. Bancroft, Toledo, OH 43606, USA
4 shared publications - Boluwatito Salami
Electrical Engineering and Computer Science Department, University of Toledo, 2801 W. Bancroft, Toledo, OH 43606, USA
1 shared publication Christian Bakole
Directorate of Econ. Affairs Tarrifs Electricity Regulatory,Authority,Kinshasa,DRC
1 shared publicationDaddy Mbombo
Directorate of Econ. Affairs Tarrifs Electricity Regulatory,Authority,Kinshasa,DRC
1 shared publicationJanvier Kamundala
Eastern Pool, Electricity Regulatory Authority,Goma,DRC
1 shared publication- Kripa Sharma
Electrical Engineering and Computer Science Department, University of Toledo, 2801 W. Bancroft, Toledo, OH 43606, USA
1 shared publication
Latest Publications
- 6 November 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Overview of the Electricity Sector and Impact of the Electricity Regulatory Authority (ARE) in the Democratic Republic of the Congo from 2020 to 2022
Historically, the national electric utility company (SNEL) had a monopoly in the electricity sector which prevented private companies from participating in the sector in the Democratic Republic of the Congo (DRC). Since 2014, the country applied reforms that allowed penetration of private companies. For effective liberalization, the Congolese government created the Electricity Regulatory Authority (ARE). This paper is a study based on the ARE's 2022 annual report, and best international practices adopted by the ARE. It presents general statistics of the DRC's electricity sector from 2020–2022. Data analysis has shown that the annual electricity production increased from 10 TWh in 2020 to 16 TWh in 2022, a 22.6% growth mostly supplied by renewable energy at 97.46%. Furthermore, 91 % of the 3282 MW projected capacity will come from hydroelectricity and solar photovoltaic energy. In 2022 alone, thanks to renewable energy, DRC avoided the emission of more than 10 Mt of CO2.
- 6 November 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Overview of the Electricity Sector and Impact of the Electricity Regulatory Authority (ARE) in the Democratic Republic of the Congo from 2020 to 2022
Historically, the national electric utility company (SNEL) had a monopoly in the electricity sector which prevented private companies from participating in the sector in the Democratic Republic of the Congo (DRC). Since 2014, the country applied reforms that allowed penetration of private companies. For effective liberalization, the Congolese government created the Electricity Regulatory Authority (ARE). This paper is a study based on the ARE's 2022 annual report, and best international practices adopted by the ARE. It presents general statistics of the DRC's electricity sector from 2020–2022. Data analysis has shown that the annual electricity production increased from 10 TWh in 2020 to 16 TWh in 2022, a 22.6% growth mostly supplied by renewable energy at 97.46%. Furthermore, 91 % of the 3282 MW projected capacity will come from hydroelectricity and solar photovoltaic energy. In 2022 alone, thanks to renewable energy, DRC avoided the emission of more than 10 Mt of CO2.
- Open Access
- 20 September 2023
- Published by Springer Nature
- p. 23-52
Batteries, Energy Storage Technologies, Energy-Efficient Systems, Power Conversion Topologies, and Related Control Techniques
- 20 September 2023
- Published by Springer Nature
- p. 23-52
Open AccessBatteries, Energy Storage Technologies, Energy-Efficient Systems, Power Conversion Topologies, and Related Control Techniques
- Open Access
- 13 August 2022
- Published by MDPI AG in Electricity
- Vol. 3 (3) , 396-409
Capacity Measurements for Second Life EV Batteries
After they reached the end of their useful EV life, lithium-ion batteries are still satisfactory for second life (SL) energy storage applications. However, the spread in their SL cell capacities may be much wider than in the EV, and this raises a question as to what type of cell voltage equalizer (EQU) should be used. Most users plan to retain the same passive EQU (PEQ) from the EV, but this means the battery capacity will be the same as the worst cell in the battery, just as it was in the EV. Unfortunately, the SL cell capacity spread may be much wider than it was in the EV, and if so, most of the cells will be under-utilized. This can be corrected by using an active EQU (AEQ) or a hybrid, such as the bilevel EQU (BEQ), to provide a capacity close to the cell average; but first, measured data is needed on the actual size of the cell capacity spread. To simplify and reduce the cost of these measurements, a new method is proposed that provides the capacities of the worst cell and the cell average.
- 13 August 2022
- Published by MDPI AG in Electricity
- Vol. 3 (3) , 396-409
Open AccessCapacity Measurements for Second Life EV Batteries
After they reached the end of their useful EV life, lithium-ion batteries are still satisfactory for second life (SL) energy storage applications. However, the spread in their SL cell capacities may be much wider than in the EV, and this raises a question as to what type of cell voltage equalizer (EQU) should be used. Most users plan to retain the same passive EQU (PEQ) from the EV, but this means the battery capacity will be the same as the worst cell in the battery, just as it was in the EV. Unfortunately, the SL cell capacity spread may be much wider than it was in the EV, and if so, most of the cells will be under-utilized. This can be corrected by using an active EQU (AEQ) or a hybrid, such as the bilevel EQU (BEQ), to provide a capacity close to the cell average; but first, measured data is needed on the actual size of the cell capacity spread. To simplify and reduce the cost of these measurements, a new method is proposed that provides the capacities of the worst cell and the cell average.
- Open Access
- 7 February 2021
- Published by MDPI AG in Electricity
- Vol. 2 (1) , 63-76
Bilevel vs. Passive Equalizers for Second Life EV Batteries
Once lithium-ion batteries degrade to below about 80% of their original capacity, they are no longer considered satisfactory for electric vehicles (EVs), but they are still adequate for second-life energy storage applications. However, once this level is reached, capacity fade increases at a much faster rate, and the spread between the cell capacities becomes much wider. If the passive equalizer (PEQ) from the EV is still used, battery capacity remains equal to that of the worst cell in the stack, just like it was in the EV. Unfortunately, the worst cell eventually becomes much weaker than the cell average, and the other cells are not fully utilized. If operated while the battery is in use, an active equalizer (AEQ) can increase the battery capacity to a much higher value close to the cell average, but AEQs are much more expensive and are not considered cost effective. However, it can be shown that the bilevel equalizer (BEQ), a PEQ/AEQ hybrid, also can provide a capacity very close to the cell average and at a much lower cost than an AEQ.
- 7 February 2021
- Published by MDPI AG in Electricity
- Vol. 2 (1) , 63-76
Open AccessBilevel vs. Passive Equalizers for Second Life EV Batteries
Once lithium-ion batteries degrade to below about 80% of their original capacity, they are no longer considered satisfactory for electric vehicles (EVs), but they are still adequate for second-life energy storage applications. However, once this level is reached, capacity fade increases at a much faster rate, and the spread between the cell capacities becomes much wider. If the passive equalizer (PEQ) from the EV is still used, battery capacity remains equal to that of the worst cell in the stack, just like it was in the EV. Unfortunately, the worst cell eventually becomes much weaker than the cell average, and the other cells are not fully utilized. If operated while the battery is in use, an active equalizer (AEQ) can increase the battery capacity to a much higher value close to the cell average, but AEQs are much more expensive and are not considered cost effective. However, it can be shown that the bilevel equalizer (BEQ), a PEQ/AEQ hybrid, also can provide a capacity very close to the cell average and at a much lower cost than an AEQ.
- Open Access
A Bilevel Equalizer to Boost the Capacity of Second Life Li Ion Batteries
There is a strong interest in second life applications for the growing number of used electric vehicle (EV) batteries, but capacity variations amongst these used cells present a problem. Even when these cells are matched for capacity, some imbalance is bound to remain, and a few lower capacity cells are also likely to develop after the pack begins its second life. Conventional cell voltage equalizers (EQU) do not address this problem, and they only provide a battery discharge capacity that is exactly equal to that of the weakest cell in the pack. This can easily result in a capacity loss of perhaps 20% to 25%, or more. This indicates the need for a new class of EQUs that can provide a discharge capacity that is close to the average of the cells, instead of the weakest cell. It is proposed to call these “capacity EQUs”, and the properties they must have are described. One such EQU is the bilevel equalizer (BEQ), described previously. This present paper provides an enhanced analysis of the BEQ and improved modelling methods. It also presents more details that are necessary to implement the microcontroller algorithm for the BEQ hardware.
Open AccessA Bilevel Equalizer to Boost the Capacity of Second Life Li Ion Batteries
There is a strong interest in second life applications for the growing number of used electric vehicle (EV) batteries, but capacity variations amongst these used cells present a problem. Even when these cells are matched for capacity, some imbalance is bound to remain, and a few lower capacity cells are also likely to develop after the pack begins its second life. Conventional cell voltage equalizers (EQU) do not address this problem, and they only provide a battery discharge capacity that is exactly equal to that of the weakest cell in the pack. This can easily result in a capacity loss of perhaps 20% to 25%, or more. This indicates the need for a new class of EQUs that can provide a discharge capacity that is close to the average of the cells, instead of the weakest cell. It is proposed to call these “capacity EQUs”, and the properties they must have are described. One such EQU is the bilevel equalizer (BEQ), described previously. This present paper provides an enhanced analysis of the BEQ and improved modelling methods. It also presents more details that are necessary to implement the microcontroller algorithm for the BEQ hardware.
- Open Access
A Bilevel Equalizer for Large Lithium Ion Batteries
Due to variations among the cells, large lithium ion batteries (LIB) such as those in battery energy storage stations (BESS) and electric vehicles (EVs) must have an equalizer (EQU) circuit to balance the cell voltages. In spite of their significant losses and other limitations, passive equalizers (PEQ) are used in most applications because they are relatively simple and low cost. Active equalizers (AEQ) reduce these PEQ problems, but are not as widely used due to their much higher cost and complexity. A new hybrid circuit called the Bilevel EQU (BEQ) combines the PEQ and AEQ to provide much higher performance than a pure PEQ but at a much lower cost than a pure AEQ.
Open AccessA Bilevel Equalizer for Large Lithium Ion Batteries
Due to variations among the cells, large lithium ion batteries (LIB) such as those in battery energy storage stations (BESS) and electric vehicles (EVs) must have an equalizer (EQU) circuit to balance the cell voltages. In spite of their significant losses and other limitations, passive equalizers (PEQ) are used in most applications because they are relatively simple and low cost. Active equalizers (AEQ) reduce these PEQ problems, but are not as widely used due to their much higher cost and complexity. A new hybrid circuit called the Bilevel EQU (BEQ) combines the PEQ and AEQ to provide much higher performance than a pure PEQ but at a much lower cost than a pure AEQ.