Ultra-low power hydrogen sensing based on a palladium-coated nanomechanical beam resonator
- 23 May 2012
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 4 (16) , 5059-5064
Abstract
Hydrogen sensing is essential to ensure safety in near-future zero-emission fuel cell powered vehicles. Here, we present a novel hydrogen sensor based on the resonant frequency change of a nanoelectromechanical clamped–clamped beam. The beam is coated with a Pd layer, which expands in the presence of H2, therefore generating a stress build-up that causes the frequency of the device to drop. The devices are able to detect H2 concentrations below 0.5% within 1 s of the onset of the exposure using only a few hundreds of pW of power, matching the industry requirements for H2 safety sensors. In addition, we investigate the strongly detrimental effect that relative humidity (RH) has on the Pd responsivity to H2, showing that the response is almost nullified at about 70% RH. As a remedy for this intrinsic limitation, we applied a mild heating current through the beam, generating a few μW of power, whereby the responsivity of the sensors is fully restored and the chemo-mechanical process is accelerated, significantly decreasing response times. The sensors are fabricated using standard processes, facilitating their eventual mass-production.Keywords
This publication has 28 references indexed in Scilit:
- Hydrogen sensors – A reviewSensors and Actuators B: Chemical, 2011
- Large arrays of chemo-mechanical nanoswitches for ultralow-power hydrogen sensingJournal of Micromechanics and Microengineering, 2010
- Joule Heating a Palladium Nanowire Sensor for Accelerated Response and Recovery to Hydrogen GasSmall, 2010
- Ultralow-power hydrogen sensing with single palladium nanowiresApplied Physics Letters, 2009
- Fast, Sensitive Hydrogen Gas Detection Using Single Palladium Nanowires That Resist FractureNano Letters, 2009
- Investigation of a Single Pd Nanowire for Use as a Hydrogen SensorSmall, 2006
- Design and performance of a microcantilever-based hydrogen sensorSensors and Actuators B: Chemical, 2003
- Hydrogen Sensors and Switches from Electrodeposited Palladium Mesowire ArraysScience, 2001
- Investigation of adsorption and absorption-induced stresses using microcantilever sensorsJournal of Applied Physics, 2001
- Hydrogen Gas Sensing Using a Pd-Coated CantileverJapanese Journal of Applied Physics, 2000